Abstract:This study was aimed to investigate the effect of steel, polypropylene (PP), and hybrid (steel + PP) fibers on high-temperature mechanical properties of reactive powder concrete (RPC). The mechanical properties considered are cubic compressive strength, axial or prismatic compressive strength, split-tensile strength, flexural strength, elastic modulus, peak strain, and stress-strain behavior. The strength recession due to high temperature was investigated at micro level by scanning electron microscope, energy dispersive X-ray spectroscopy, X-ray diffraction, mercury intrusion porosity, thermogravimetric, and differential scanning calorimetry analyses. The high-temperature tests were carried out at target temperatures of 120, 300, 500, 700, and 900 °C. The hot-state compressive strength of RPC started to decrease at 120 °C; however, a partial recovery at 300 °C and a gradual decrease above 300 °C were observed. The degradation of split-tensile strength, flexural strength, and elastic modulus were gradual with increasing temperature despite the effect of different fibers. Whereas, the peak strain was gradually increasing up to 700 °C. However, after 700 °C, it remained unchanged. Steel fiber reinforced RPC (SRPC) and hybrid fiber reinforced RPC (HRPC) showed a ductile behavior. PP fiber reinforced RPC (PRPC) showed a quite brittle behavior up to 300 °C; however, further heating made the microstructure porous and it became ductile too. Overall the performance of SRPC and HRPC were superior to PRPC because of higher modulus of elasticity, higher strength, and better fire resistance of steel fibers. Fiber reinforced RPC was found to have better fire resistance than traditional types of concrete based on comparative studies with the provisions of design codes and earlier research. The constitutive equations developed can be utilized in computer programs for structural design of RPC structures exposed to fire.

Experimental investigation on the dynamic tensile behavior of graded steel-fiber RPC

Dynamic Behavior of Reactive Powder Concrete in Split Hopkinson Pressure Bar Testing

Experimental Research the Shearing Performance of Grading-Fiber Reinforced Reactive Powder Concrete

Experimental Study on the Spalling Strength of Fiber Reactive Powder Concrete

Experimental Investigation on the Dynamic Compressive Behavior of Rubberized Concrete

Experimental Studies on Concrete Filled Steel Tubes under High Strain Rate Loading

Experimental research on seismic behavior of concrete-filled reactive powder concrete tubular columns

Experimental Research on Composite Action of Concrete-filled RPC Tube under Axial Load

High-strain Rate Compressive Behavior of CFRP Confined Concrete: Large Diameter SHPB Tests

Strength of Concrete Filled Steel Tubes under High-Strain Rate Loading

Experimental and numerical study on tensile strength and failure pattern of high performance steel fiber reinforced concrete under dynamic splitting tension

Experimental Study of Dynamic Tensile Strength of Steel-Fiber-Reinforced Self-Compacting Concrete Using Modified Hopkinson Bar

Experimental Study on Dynamic Splitting Characteristics of Carbon Fiber Reinforced Concrete

Dynamic tensile strength tests for steel fiber reinforced concrete

Effect of Fibers on High-Temperature Mechanical Behavior and Microstructure of Reactive Powder Concrete

Experimental Investigation on Strain Rate Effect of High-Performance Fiber Reinforced Cementitious Composites Subject to Dynamic Direct Tensile Loading

Dynamic Compressive Strength Tests of Corroded SFRC Exposed to Drying–Wetting Cycles with a 37 mm Diameter SHPB

Dynamic tensile behaviour of fibre reinforced concrete with spiral fibres

Characteristics of RPC-filled steel tubular puncheons with ultra high performance subjected to axial compressive loading

Experiment study on reactive powder concrete beams using spirals reinforcement under torsion

Research on Compressive Impact Dynamic Behavior and Constitutive Model of Polypropylene Fiber Reinforced Concrete