Abstract:This paper presents a novel active inductor (AI) to improve the performance of a down‐conversion active mixer in terms of conversion gain (CG) and flicker noise. The proposed AI exhibits negative resistance and partially flat inductance over a wide frequency band of 0.5–4.5 GHz. The proposed mixer achieves a conversion gain of 37.6 dB and a flicker noise corner frequency of 6 kHz. Additionally, it exhibits a third‐order intermodulation intercept point (IIP3) of −5.2 dBm and a double‐sideband noise figure (DSB‐NF) of 6.1 dB at the IF output frequency of 10 MHz. Operating with a 1.5 V supply, the proposed mixer consumes 10.6 mW of power. This paper presents a novel active inductor (AI) to improve the performance of a down‐conversion active mixer in terms of conversion gain (CG) and flicker noise. The proposed AI exhibits negative resistance and partially flat inductance over a wide frequency band of 0.5–4.5 GHz. The effect of inserting the AI between the source of the switching quad of a Gilbert cell mixer is theoretically analyzed. The proposed inductor‐less mixer, designed to operate at a 2.4‐GHz RF input frequency and a 10‐MHz IF output frequency, employs current reuse and self‐forward body bias (SFBB) techniques. The proposed circuit is simulated in Cadence Spectre‐RF using RF‐TSMC 0.18‐μm CMOS technology. Post‐layout simulations demonstrate that the proposed AI significantly reduces flicker noise by over 23 dB at an IF output frequency of 1 kHz and improves the CG by over 16 dB at an RF frequency of 2.4 GHz. The proposed mixer achieves a CG of 37.6 dB and a flicker noise corner frequency of 6 kHz. Additionally, it exhibits a third‐order intermodulation intercept point (IIP3) of −5.2 dBm and a double‐sideband noise figure (DSB‐NF) of 6.1 dB at the IF output frequency of 10 MHz. Operating with a 1.5‐V supply, the proposed mixer consumes 10.6 mW of power.

Adaptive calibration of IIP2 in direct down-conversion mixers with modified LMS algorithm

Digitally Assisted IIP2 Calibration for CMOS Direct-Conversion Receivers

A Low-Power Low-Noise Direct-Conversion Front-End with Digitally Assisted IIP2 Background Self Calibration

A Frequency-Domain I/Q Imbalance Calibration Algorithm for Wideband Direct Conversion Receivers Using Low-Cost Compensator.

A 27 - 57 GHz Down-conversion Mixer with Bulk Injection Technique

CMOS RF mixer with digitally enhanced IIP2

Photonic Down-Conversion and Linearisation with Tunable IF Bandwidth and Improved Spurious-Free Dynamic Range

An Effective DC Offset Calibration Method Combined with Analog and Digital Circuits for Direct Conversion Receivers

High-Linearity Direct Conversion Receiver with the Transconductance Equalization Technique and DCOC Method

A 0.1-1.9Ghz 65nm CMOS Variable-Gain Mixer-First Receiver with DSA and Noise-Shaping TIA.

A Novel BiST and Calibration Technique for CMOS Down-Converters

CMOS High-ⅡP2 Mixer for Direct Conversion Receivers

Digital Calibration Of Gain And Linearity In A Cmos Rf Mixer

A 2.1–2.5 GHz high linearity and low noise down-conversion active mixer

Adaptive Zero-IF I/Q Imbalance and DC Offset Calibration Algorithm

Low-Complexity Calibration Of Joint Tx/Rx I/Q Imbalance In Wideband Direct-Conversion Transceiver

Calibration of Frequency Response Mismatches in Time‐interleaved Analog‐to‐digital Converter Based on Adaptive Method

Adaptive Digital Calibration Techniques for Narrow Band Low-If Receivers with On-Chip Pll

Lms-Fir Based Digital Background Calibration For The Four-Channel Time-Interleaved Adc

Design and Realization of a 2 GHz Downconversion Mixer

An Inductor‐Less Zero‐IF Down‐Conversion Mixer With Low Flicker Noise and High Conversion Gain