Abstract:Scan based built-in self-test (BIST), which naturally extends scan-based test methodology with test patterns applied from test equipment to BIST, can be used for the self test of sequential circuits and attain higher fault coverage. If the circuit under test (CUT) contains multiple parallel scan chains, a parallel generator is needed. Known as the common pseudo-random pattern generator (PRPG), an LFSR can be configured to generate a random pattern stream. The PRPG-based patterns may be applied to the existing scan architecture directly from the LFSR, or through some decorrelation logic. In order to attain higher fault coverage, it is very important to analyze the test pattern generation in the scan based BIST. The paper presents a kind of scheme for test pattern generation in the scan based BIST for the circuits with multiple scan chains. In the test pattern generation scheme the PRPG, which is implemented by an LFSR, shifts the sequences into all scan chains simultaneously. The correlativity weight R(M) of multiple scan chains is also defined in the paper. Based on the analysis of the different degree effect on fault coverage due to the different configuration of multiple scan chains, one conclusion is drawn that the probability that the fault coverage is reduced is increased with an increase of the correlativity weight R(M). If the circuit is tested by the multiple scan chains with the minimum R(M), the probability that the fault coverage is reduced is least. In the paper a method to construct multiple scan chains with minimum correlativity weight R(M) is proposed to overcome the bad effect on fault coverage due to the correlation between scan chains. Furthermore the minimum set of deterministic patterns is generated for hard-to-test faults by ATPG and the set is used to design the bit modifying logic circuit (BML), which is located between multiple scan chains and the CUT. Through BML the signals in multiple scan chains are controlled to input to the CUT. When the test control signal is low, the test patterns in multiple scan chains are input into the CUT directly. When the test control signal is high, the value of the signals at certain bit positions in the multiple scan chains are modified by BML and the changed test patterns are input into the CUT to test hard-to-test faults for complete fault coverage. The experiments on some ISCAS'89 benchmark circuits show that the complete fault coverage can be obtained by the test method presented by the paper. The overhead of BML is also analyzed.

Seed Encoding Scheme Based on Scan Forest Architecture

A Secure Scan Method for Crypto Chips

Reconfigured Scan Forest For Test Application Cost, Test Data Volume, And Test Power Reduction

A Cost-Effective Scan Architecture for Scan Testing with Nonscan Test Power and Test Application Cost

P4CTM: Compressed Traffic Pattern Matching Based on Programmable Data Plane

Design for Cost Effective Scan Testing by Reconfiguring Scan Flip-Flops

Scan Testing for Complete Coverage of Path Delay Faults with Reduced Test Data Volume, Test Application Time, and Hardware Cost

Compact Test Generation with an Influence Input Measure for Launch-On-Capture Transition Fault Testing

Design of the 2-dimensional test patten compression based on TRC-LFSR structure

BIST Technique Based on the Scan Forest Architecture

Scan-based BIST using an improved scan forest architecture

Low-Power Scan Testing for Test Data Compression Using a Routing-Driven Scan Architecture

Scan Chain Configuration Based X-filling for Low Power and High Quality Testing.

A Power-Effective Scan Architecture Using Scan Flip-Flops Clustering And Post-Generation Filling

Test Pattern Generation Based on Variable-Cycle Reseeding LFSR Structure

Compressing Test Data for Deterministic BIST Using a Reconfigurable Scan Arhcitecture

A Novel Scan Segmentation Design for Power Controllability and Reduction in At-Speed Test.

Test Pattern Generation in Built-In Self-Test with Multiple Scan Chains

An Obfuscation Scheme of Scan Chain to Protect the Cryptographic Chips.

Low-power Technique of Scan-Based Design for Test

A Power Efficient BIST TPG Method on Don't Care Bit Based 2-D Adjusting and Hamming Distance Based 2-D Reordering