Abstract:Gelcasting is a new ceramic forming technology for making complex-shaped ceramic products with high performance. The processes used in gelcasting are similar to processes often used in conventional ceramic forming process. However, when new high performance materials are introduced with the aim to improve the strength, defects such as air bubbles or agglomerates that can be found in many traditional ceramic materials are no longer be allowed since this would reduce the performance and reliability of the final ceramic products. The aim of this thesis project was to find an appropriate recipe of the ceramic suspension meanwhile improving the process of gelcasting and obtaining ceramic products with excellent mechanical behavior. To achieve this specified target, alumina and zirconia powders were studied in the following experiments which included rheological measurement of viscosity and storage modulus measurement for ceramic suspensions and drying shrinkage measurement of cast materials. The binder was burned out and the density was measured for ceramic materials sintered at different temperatures. The mechanical strength of sintered materials with high density was evaluated and the microstructure of fracture surfaces of ceramic samples was studied. Through rheological measurement, a good balance between fluidity and solid content of ceramic suspension was found. For alumina suspensions a solid content of 55vol% was selected and for zirconia solid contents of 46, 48 and 50vol% were studied. A monomer was dissolved in the suspension and an initiator was added to facilitate the polymerization of the monomer when the temperature was increased to around 70oC. The failure analysis of the fractured bending bars showed that the defects that caused the failure were not air bubbles but agglomerates. As a result, in future research for ceramic gelcasting with the intention to improve the mechanical strength, the suggestion is to use an appropriate recipe for the ceramic suspension and focus on elimination of granules and agglomerates from the suspension

Mechanical Properties of ZTA Formed by Gelcasting

Rheological Properties and Gelcasting Behavior of Ultrafine Zro2 Suspension

Preparation Of Zta Powders By Spray Granulation And Properties Of Sintered Zta Composites

Effect of Ti Addition on the Microstructure and Mechanical Properties of Cast Mg-Gd-Y-Zn Alloys

Microstructure and mechanical properties of ZTA fabricated by liquid phase sintering

Preparation of Ultrafine Zirconia Suspension for Gelcasting

Aqueous Gelcasting of ZrB2–SiC Ultra High Temperature Ceramics

Water based gelcasting of lead zirconate titanate

Gel Casting of High Strength Ceramics

Influence of Solid Loading in the Gel-Casting Process on the Microstructure and Properties of Porous YSZ Ceramics

MECHANICAL AND WEAR PROPERTIES OF ZTA CERAMICS

Effect Of Solid Loading On Properties Of Cr2o3 Refractories By Aqueous Gelcasting

Preparation and properties of zrb 2-sic composites by centrifugal gel casting process

Microstructure and mechanical properties of ZrB2-SiC composites fabricated by the centrifugal gel casting

Effects of sintering velocity on the microstructure and mechanical properties of hot-pressed ZrB2-SiC-ZrO2f ceramics

Effect of Variation in Zr Content on Microstructure and High-Temperature Tensile Properties of a Γ-Tial Alloy

Preparation and Characterization of Stable ZrB<sub>2</sub>-Based Ultra-High Temperature Ceramics Slurry by Aqueous Gelcasting

Fabrication of ZrB 2 -Sic Ceramic Composites by Optimized Gel-Casting Method

Effects of ZrC content on the microstructure and mechanical property of ZrC/ZTA composites consolidated by hot pressing

Effect of Ti addition on mechanical properties of Zr-based bulk metallic glasses

Microstructures and Mechanical Properties of Cast Nb-Ti-Si-Zr Alloys