Abstract:Gelcasting is a new ceramic forming technology for making complex-shaped ceramic products with high performance. The processes used in gelcasting are similar to processes often used in conventional ceramic forming process. However, when new high performance materials are introduced with the aim to improve the strength, defects such as air bubbles or agglomerates that can be found in many traditional ceramic materials are no longer be allowed since this would reduce the performance and reliability of the final ceramic products. The aim of this thesis project was to find an appropriate recipe of the ceramic suspension meanwhile improving the process of gelcasting and obtaining ceramic products with excellent mechanical behavior. To achieve this specified target, alumina and zirconia powders were studied in the following experiments which included rheological measurement of viscosity and storage modulus measurement for ceramic suspensions and drying shrinkage measurement of cast materials. The binder was burned out and the density was measured for ceramic materials sintered at different temperatures. The mechanical strength of sintered materials with high density was evaluated and the microstructure of fracture surfaces of ceramic samples was studied. Through rheological measurement, a good balance between fluidity and solid content of ceramic suspension was found. For alumina suspensions a solid content of 55vol% was selected and for zirconia solid contents of 46, 48 and 50vol% were studied. A monomer was dissolved in the suspension and an initiator was added to facilitate the polymerization of the monomer when the temperature was increased to around 70oC. The failure analysis of the fractured bending bars showed that the defects that caused the failure were not air bubbles but agglomerates. As a result, in future research for ceramic gelcasting with the intention to improve the mechanical strength, the suggestion is to use an appropriate recipe for the ceramic suspension and focus on elimination of granules and agglomerates from the suspension

Gelcasting of PZT

Water based gelcasting of lead zirconate titanate

Application of Gelcasting to the Fabrication of Piezoelectric Ceramic Parts

Enhanced Piezoelectric Properties of PZT Ceramics Prepared by Direct Coagulation Casting Via High Valence Counterions (DCC–HVCI)

Anti-crack machining of PZT ceramics for fabricating piezocomposites by using gelcasting technique

Rapid Prototyping of Piezoelectric Ceramics Via Selective Laser Sintering and Gelcasting

Processing and properties of porous PZT ceramics from particle-stabilized foams via gel casting

Investigation of the Additive Induced Doping Effects in Gelcast Soft Lead Zirconate Titanate Ceramics

Gelcasting of nano-size Y-TZP

Microstructure and electrical properties of porous PZT ceramics with unidirectional pore channel structure fabricated by freeze-casting

Rheological Properties and Gelcasting Behavior of Ultrafine Zro2 Suspension

Dispersion And Gelcasting Of Zirconium Diboride Through Aqueous Route

Preparation of Ultrafine Zirconia Suspension for Gelcasting

Gelcasting Based Solid Freeform Fabrication of Piezoelectric Ceramic Objects

Porous PZT Ceramics with High Hydrostatic Figure of Merit and Low Acoustic Impedance by TBA-Based Gel-Casting Process

Gelcasting of Aqueous Mesocarbon Microbead Suspension

Rheological properties of nanometer tetragonal polycrystal zirconia slurries for aqueous gel tape casting process

Gel Casting of High Strength Ceramics

Gelcasting of BaTiO3 ceramic powders

Aqueous Gelcasting of ZrB2–SiC Ultra High Temperature Ceramics

Improved Gelcasting