Abstract:Cationic polymers (e.g. polyacrylamide) having a high molecular weight require a much lower dose than inorganic metal salts (e.g. AlCl 3 , FeCl 3 , or Al 2 (SO 4 ) 3 ) to produce dense compact flocs with good settling characteristics. This study investigated the effect of a continuous low dosing of cationic polyacrylamide (PAM) to achieve efficient algal removal from a 1-ha High Rate Algal Pond (HRAP) treating domestic wastewater in New Zealand. Firstly, standard jar tests were conducted in laboratory conditions. A wide range of PAM dose rates (0.25–9 mg/L), mixing periods (60–250 s) and settling times (0–120 min) were tested on HRAP effluent samples to determine optimal operational parameters for the 1-ha HRAP in terms of TSS and turbidity removal. PAM addition effectively promoted flocculation of the wastewater algal biomass, removing 78% of TSS (from 135 to 30 mg/L) and 70% of turbidity (from 41 to 12 NTU) at a dose of only 4 mg/L. The jar tests determined that ∼120 s of vigorous mixing followed by 15-min of settling were sufficient to promote the formation of dense/settleable algal flocs. Continuous addition of PAM to the hectare-scale HRAP effluent at the 4 mg/L laboratory determined dose rate was found to improve TSS removal in the Algal Harvest Pond (AHP) by ∼55% (from 13% to 68%). The TSS concentration and turbidity of the AHP effluent were consistently maintained <50 mg/L and <18 NTU respectively. Furthermore, a ∼1-log E. coli removal (from 1 × 10 5 to 1 × 10 4 MPN/100 ml after settling) was also achieved in the AHP as a result of the algal floc formation and removal. Overall, this study demonstrated that addition of low levels of the chemical flocculant (e.g. cationic polyacrylamide) to the HRAP effluent can greatly improve algal solid removal (at least 50%) with a minimum chemical cost (∼$0.05 NZD/m 3 of wastewater).

Treatment of High Concentration Wastewater in Polyacrylamide Production by Complex Coagulation Process

Study on the optimization of polyacrylamide wastewater treatment by coagulation-adsorption

Treatment of polyacrylamide wastewater by powder activated carbon treatment process

Treatment of Wastewater from the Production Process of P-Aminobenzoic Acid with Polymeric Adsorbents

Treatment of Fiberglass Wastewater

Study on the coagulation treatment of activated dye wastewater

Improvement of alum and PACl coagulation by polyacrylamides (PAMs) for the treatment of pulp and paper mill wastewater

Treatment of pulp and paper mill wastewater by polyacrylamide (PAM) in polymer induced flocculation

Treatment Project of Organophosphorus Pesticide Wastewater

Pretreatment of a textile wastewater from alkali reduction,printing and dyeing operations

Synthesis of cationic polyacrylamide via inverse emulsion polymerization method for the application in water treatment

Pretreatment of Wastewater in Amine C Acid Manufacture by Coagulation-Catalytic Oxidation

Treatment of p-Nitrophenol Production Wastewater by Activated Carbon Fiber Adsorption

Preparation of Cationic Polyacrylamide Suspension and Its Application in Oilfield Wastewater Treatment

Experimental Study on Application of PAC Produced Electrochemically in Water and Wastewater Treatment

Continuous low dosing of cationic polyacrylamide (PAM) to enhance algal harvest from a hectare-scale wastewater treatment high rate algal pond

A novel preparation method of polyaluminum chloride/polyacrylamide composite coagulant: Composition and characteristic

An Effective Flocculation Method to the Kaolin Wastewater Treatment by a Cationic Polyacrylamide (CPAM): Preparation, Characterization, and Flocculation Performance

Study on Treatment of Polyacrylonitrile Fiber Wastewater by Coagulation-Anaerobic-Anoxic-Aerobic Process

Experimental study on reducing the viscosity of sewage containing PAM catalyzed by low temperature plasma synergistic AC/Mn + TiO2

Coagulation Pretreatment of Highly Concentrated Acrylonitrile Wastewater from Petrochemical Plants.