Abstract:Cationic polymers (e.g. polyacrylamide) having a high molecular weight require a much lower dose than inorganic metal salts (e.g. AlCl 3 , FeCl 3 , or Al 2 (SO 4 ) 3 ) to produce dense compact flocs with good settling characteristics. This study investigated the effect of a continuous low dosing of cationic polyacrylamide (PAM) to achieve efficient algal removal from a 1-ha High Rate Algal Pond (HRAP) treating domestic wastewater in New Zealand. Firstly, standard jar tests were conducted in laboratory conditions. A wide range of PAM dose rates (0.25–9 mg/L), mixing periods (60–250 s) and settling times (0–120 min) were tested on HRAP effluent samples to determine optimal operational parameters for the 1-ha HRAP in terms of TSS and turbidity removal. PAM addition effectively promoted flocculation of the wastewater algal biomass, removing 78% of TSS (from 135 to 30 mg/L) and 70% of turbidity (from 41 to 12 NTU) at a dose of only 4 mg/L. The jar tests determined that ∼120 s of vigorous mixing followed by 15-min of settling were sufficient to promote the formation of dense/settleable algal flocs. Continuous addition of PAM to the hectare-scale HRAP effluent at the 4 mg/L laboratory determined dose rate was found to improve TSS removal in the Algal Harvest Pond (AHP) by ∼55% (from 13% to 68%). The TSS concentration and turbidity of the AHP effluent were consistently maintained <50 mg/L and <18 NTU respectively. Furthermore, a ∼1-log E. coli removal (from 1 × 10 5 to 1 × 10 4 MPN/100 ml after settling) was also achieved in the AHP as a result of the algal floc formation and removal. Overall, this study demonstrated that addition of low levels of the chemical flocculant (e.g. cationic polyacrylamide) to the HRAP effluent can greatly improve algal solid removal (at least 50%) with a minimum chemical cost (∼$0.05 NZD/m 3 of wastewater).

Continuous low dosing of cationic polyacrylamide (PAM) to enhance algal harvest from a hectare-scale wastewater treatment high rate algal pond

Treatment of Polyacrylamide Production Wastewater by Multistage Contact Reactor with Activated and Anammox Sludge

UV-initiated Polymerization of Acid-and Alkali-Resistant Cationic Flocculant P(AM-MAPTAC): Synthesis, Characterization, and Application in Sludge Dewatering

Application of Algal-Mycelial Pellets in the Treatment of the Mariculture Wastewater

Nutrients Removal Mechanisms in High Rate Algal Pond Treating Rural Domestic Sewage in East China

Application of Polyacrylamide Flocculation with and Without Alum Coagulation for Mitigating Ultrafiltration Membrane Fouling: Role of Floc Structure and Bacterial Activity

Combined Membrane-High Rate Algal Pound for Advanced Treatment of Municipal Wastewater Treatment Plant Effluent

Synthesizing cationic polymers and tuning their properties for microalgae harvesting

Bench-scale and Pilot-Scale Evaluation of Coagulation Pre-Treatment for Wastewater Reused by Reverse Osmosis in a Petrochemical Circulating Cooling Water System

Comparison of the wastewater treatment performance of continuously and discontinuously mixed high-rate algal ponds at Kingston on Murray

Preparation of Cationic Polyacrylamide Suspension and Its Application in Oilfield Wastewater Treatment

Treatment of High Concentration Wastewater in Polyacrylamide Production by Complex Coagulation Process

Revitalizing urban lake cleanup: optimizing flocculation and dewatering of dredged sludge using cation polyacrylamide

The Impact of Anionic Polyacrylamide (APAM) on Ultrafiltration Efficiency in Flocculation-Ultrafiltration Process.

Study of the Enhanced Removal of Microsystis Aeruginosa by Adding Kaolin and PAM in PAC Flocculation Process

Removal of Polyacrylamide from Oilfield Wastewater by Coagulation Treatment Method

Using Polyaluminum Chloride and Polyacrylamide to Control Membrane Fouling in A Cross-Flow Anaerobic Membrane Bioreactor

The Pre-Treatment of Submerged Ultrafiltration Membrane by Coagulation—effect of Polyacrylamide As a Coagulant Aid

Impact of Poly Dimethyldiallylammonium Chloride on Membrane Fouling Mitigation in a Membrane Bioreactor

An Efficient Microalgal Biomass Harvesting Method with a High Concentration Ratio Using the Polymer-Surfactant Aggregates Process

Study on Removal of Algae from Outflow of High Rate Algal Pond