Abstract:A continuous flow system that can make the process variable more stable was proposed to prepare NaA zeolite membranes on the inner-surface of alumina hollow fiber, in which the gel solution was recirculated and only preheated at the required section, thus avoiding the unnecessary depletion of the nutrients in the bulk. The influence of synthesis parameters including temperature, flow rate and time over the property of obtained membrane were investigated. The thickness and the morphology of the membranes were explored by SEM. Their separation performance for dehydration of ethanol/water mixture was tested in a pervaporation (PV) set-up with the feed flowing through the membranes' lumen-side, which varied significantly when the feed flowed at different rates. The reason was inquired by studying the PV behavior at different operating conditions. It was found that the boundary layer resisted the heat transfer, leading to the lower temperature of PV at membrane surface than that of the feed, therefore, the intrinsic PV performance of the membrane could hardly be obtained when the feed flew at low rate. The optimal performance of 19.7 kg/m(2) h for the permeation flux and more than 80,000 for the separation factor was tested at the flow rate of 148 mL/min with 90 wt% ethanol/water solution at 348 K, yielding an unprecedented PV performance to our knowledge. The results revealed the high reproducibility and uniformity of the membranes prepared by continuous flow system, as well as that the zeolite membranes located on ceramic hollow fiber inner-surface possessed a competitive advantage of PV performance especially of the permeation flux, which have not been realized by the previous studies and may generalize to the other zeolite or metal-organic frameworks (MOF) membranes.

Synthesis and pervaporation properties of NaA zeolite membranes prepared with vacuum-assisted method

Manipulation of the Surface Microstructure and Its Effects on the Flux of NaA Zeolite Membranes in Pervaporation

A study on the pervaporation of water–acetic acid mixtures through ZSM-5 zeolite membranes

Preparation of high-performance zeolite NaA membranes in clear solution by adding SiO2 into Al2O3 hollow-fiber precursor

Zeolite NaA membranes supported on alumina hollow fibers: Effect of support resistances on pervaporation performance

A Facile Preparation of High Flux NaA Zeolite Membranes by Direct Secondary Growth of Wet Gel Layer

The preparation of zeolite NaA membranes on the inner surface of hollow fiber supports

High performance zeolite NaA membranes synthesized on the inner surface of zeolite/PES–PI blend composite hollow fibers

Electrophoretic Technique for Hydrothermal Synthesis of NaA Zeolite Membranes on Porous Α-Al2o3 Supports

Preparation of Asymmetric Zeolite NaA Membrane Layers by Vapor Phase Transfer and Seeded Growth Method

Hydrothermal Synthesis of NaA Zeolite Membrane Together with Microwave Heating and Conventional Heating

Influences of adding organic intermediate layer on membrane formation and properties

Silane-modified NaA/PAAs hybrid membranes for ethanol dehydration by pervaporation

High-flux NaA Zeolite Pervaporation Membranes Dynamically Synthesized on the Alumina Hollow Fiber Inner-Surface in a Continuous Flow System

Preparation of Zeolite NaA Membranes on Macroporous Alumina Supports by Secondary Growth of Gel Layers

Preparation of zeolite MFI membranes on alumina hollow fibers with high flux for pervaporation

Hydrothermal Synthesis of Uniform and Dense Naa Zeolite Membrane in the Electric Field

Synthesis and properties of A-type zeolite membranes by secondary growth method with vacuum seeding

Preparation and Characterization of NaA Zeolite Membranes on Inner-surface of Four-channel Ceramic Hollow Fibers

Silane-Modified Naa Zeolite/Paas Hybrid Pervaporation Membranes for the Dehydration of Ethanol

Preparation of NaA Zeolite Membrane on Macroporous α-Al2O3 Support by Two-Step-Seeding Method