Abstract:Fused silica crucibles are commonly used in the fabrication process of solar grade silicon ingots. These crucibles are manufactured from high purity natural quartz sand and as a consequence, their properties are influenced by the presence of water and hydroxyls in the raw quartz. In this work, diffuse reflectance IR, 1H magic angle spinning NMR, and Raman spectroscopy were used to investigate the influence of thermal treatment on water and hydroxyl groups in high purity natural quartz sand. Most of the water in dry sand is present in the form of closed inclusions within the quartz grains which were detected in Raman imaging studies, even after thermally treating the samples at 600 °C. Only after heating to 900 °C did this water completely vanish, most likely as a result of rupturing of the inclusions. However, newly formed OH groups, identified as isolated and hydrogen bound OH were observed as products of the reaction between water and quartz. Similarly, liquid water was observed in NMR spectra even after treatment at 600 °C while at temperatures >900 °C, only non-interacting silanol groups were present. The comparison of the temperature dependence of the IR and NMR spectra also yields insight into the assignment of the OH stretching mode region of the IR spectrum in this system. The intensity of water related bands decreases while the intensity of OH bands first increases and then decreases with increasing temperature. The band intensity of Al-rich defects as well as the characteristic feature at 3200 cm-1 does not follow the temperature dependence of typical water peaks. It is also shown that leaching the quartz sand in HF solution helps to remove water from inclusions, likely by forming pathways for fluid flow inside the quartz grains. Milling of the samples caused formation of an additional type of hydroxyl group, possibly due to partial amorphisation of the surfaces of the quartz grains surface during the process. The results improve the basis for a knowledge-based processes development for the processing of high purity natural quartz.

Influence of Drying System on Quartz Sand Ceramic Body

SUPPLEMENTARY EXPERIMENT INVESTIGATION ON THERMAL CONDUCTIVITY MEASURED BY STEADY-STATE PLATE METHOD

INFLUENCE OF SINTERING PROCESS ON PROPERTY OF POROUS CERAMICS FROM QUARTZ SAND

The Effects of Mineral Composition and Sintering Temperature on Synthetic Mullite

Influence of Bentonite Dosage on Strength of Porous Ceramic with Quartz Sand

Low-temperature Preparation of Humidity Self-Regulating Porous Ceramics with High Strength Performance

Effects of heat-dry curing temperature on porous silicate cement membranes fabricated by the coupling process of freeze casting and heat-dry curing

Influence of Drying Procedure on the Mesoporosity and Surface Fractal Dimensions of Silica Xerogels Prepared with Different Agitation Methods

Qantitative Pattern of the Change in Microstructure and Surface Properties of Electric Ceramic During Sintering Processes

Thermal properties of sandstone after treatment at high temperature

Effect of Sintering Temperature on Mechanical Properties of Porous Silica Ceramic

Influence of Supercritical and Natural Drying Methods on Structure and Properties of Porous Silicon

Effects of heat-treatment temperature and holding time on the microstructure and mechanical properties of lithium disilicate glass-ceramics

The Effect of SiO2 Addition on Phase and Microstructure of Porous Silica Ceramic

Effects of high temperature thermal treatment on the physical properties of clay

Experimental study on the shear characteristics of quartz sand exposed to high temperatures

Effect of Control Technology on Properties of Quartz Porous Brick

Structural evolution of water and hydroxyl groups during thermal, mechanical and chemical treatment of high purity natural quartz

Experimental and Numerical Analyses of Temperature-Reducing-Effect by Heat of Water Evaporation on a Moss-Greening Ceramic Utilizing Waste Silica

The microstructure, phase transformation and sinterability of desert sand

Investigation the Effect of Additive Content and Sintering Temperature on the Mechanical Properties of Clay-Bonded and Glass-Bonded Ceramic Parts Produced by Low Injection Molding Method