Abstract:The electrochemical co-deposition of Cr-Co oxide coatings at room temperature on 304 stainless steel (SS) was studied using an electrolyte composed of a mixture of ethylene glycol (EG), hydrated metal chloride salts (MCln∙YH2O), and water as a secondary hydrogen donor (HBD). Metallic Cu and Ni undercoats were applied to improve the adhesion of a posterior Cr-Co metallic and oxide layer. The electroactive events that took place during both electrodeposition processes were studied using cyclic voltammetry (CV) and chronoamperometry. The microstructure and composition of the surface layers were studied using scanning electron microscopy (SEM/EDS), X-ray diffraction (XRD) and cross-sectional elemental mapping via transmission electron microscopy (TEM). The surface of steel with the Cr-Co:EG-H2O coating showed greater resistance to pitting corrosion (123.93 mV) compared to untreated stainless steel (62.3 mV). This sample showed a large hystere-sis area, which is associated with high resistance to pitting corrosion by the occurrence of a re-passivation of the sample at a Erep value of 24.31 mV. After the cyclic potentiodynamic polariza-tion (CPP) test, the lowest specific mass loss (0.001 mg/cm2) was achieved for the AISI 304 SS sample coated using EG-water solvents (Cr-Co:EG-H2O), while the untreated AISI 304 SS reached a higher specific mass loss (0.01 mg/cm2). The Electrochemical Impedance Spectroscopy (EIS) tests showed that the uniform corrosion resistance varied significantly from the untreated AISI 304 SS (35 kΩ) to the coated sample (57 kΩ), which is attributed to the protection provided by the chromium and cobalt oxides coating. The best corrosion resistance achieved was correlated with a superhydrophobic character (with a contact angle of 158.41°) of the Cr-Co coatings. This was in turn a consequence of a needle-like morphology characteristic of these oxides.

Growth Mechanism of SrSO4 Coatings by Electrochemical Deposition Method

Effect of EDTA on Electrodeposition of Hydroxyapatite Coatings

Synthesis and Charaterization of Silicon-Substituted Hydroxyapatite Coating by Electrochemical Deposition on Ti Substrate

Effect of Supersaturation on the Morphology of Hydroxyapatite Crystals Deposited by Electrochemical Deposition on Titanium

Electrolytic Deposition of Hydroxyapatite Coating on CoNiCrMo Substrates

Mechanism for Electrodeposition of Lead Dioxide Coating on Stainless Steel Substrate

Electrodeposition of SrF2 and rare earth doped SrF2 films and its optical properties

Preparation of Al-Cr-Fe Coatings by Heat Treatment of Electrodeposited Cr/Al Composite Coatings

Nucleation and Growth of Anodic Electrodeposited Cerium Oxide Thin Film

EFFECT OF THE COMPLEX IN ELECTRODEPOSITION ON CdS PHOTOVOLTAIC MATERIALS

Synthesis and Growth Mechanisms of Nanoscale SrSO_4 Powderswith Different Crystallographic Morphologies

FeS2 (pyrite) Electrodeposition Thin Films and Study of Growth Mechanism

First-principle calculations of crystal structure evolution of electrodeposited iron coating

A Study of Sn-Bi Alloy Electrodepositing Process

Effects and Mechanism of ITO and ZnO Substrate on Surface Morgraphology and Structural of Electrodeposited Cu2O Thin Films

The effects of main salt concentrations and deposition voltages on the structures and properties of cathode plasma electrolytic deposited Cr2O3 coatings

The Effect of Complexing Agents on the Oriented Growth of Electrodeposited Microcrystalline Cuprous Oxide Film

Electrochemical Nucleation and Growth of Sn Onto Double Reduction Steel Substrate from a Stannous Fluoborate Acid Bath

A Simple Chemical Method for the Deposition of Highly Crystallized Srmoo4 Films

Preparation of Crystalline Chromium Coating on Cu Substrate Directly by DC Electrodepositing from Wholly Environmentally Acceptable Cr(III) Electrolyte

Cr-Co Oxide Coatings Resistant to Corrosion, Electrodeposited on 304 SS Using an Ethylene Glycol-Water Solvent