Abstract:In this paper, the impact spot welding of metallic plates was investigated both experimentally and numerically using a single-stage gas mixture detonation apparatus. The impact spot welding process was carried out on aluminum alloy and steel materials using rigid steel projectiles. In this process, the mixture of oxygen and acetylene was detonated in a combustion chamber to launch the projectile. The masses of flat- and spherical-nosed projectiles were 270 and 230 g, respectively. The impact velocity was measured in all experiments. The cross-sections of the weld spots were inspired by a scanning electron microscope to assess the quality of welding. For several experiments, wavy interfaces were observed showing there is a good bonding. For numerical simulation of the process, Abaqus/Explicit software was used and the deformation and failure mechanisms of impact spot-welded specimens were further investigated. The Johnson–Cook thermoplasticity model along with its failure model was utilized to predict the behavior of metallic materials. The numerical simulation results were in good agreement with those obtained from experiments in terms of the deformation mode and failure pattern. The propagation of the wave on the surface of the flyer plate was further studied. The results showed that the stress waves start from the center and propagate to the corners of the plate. To numerically evaluate the welding quality, two parameters of the shear stress at the collision point as well as the equivalent plastic strain for the flyer and target plates were obtained in the numerical simulation. The numerical results showed opposite directions of shear stress for flyer and base plates at the contact point, which can be used as proof for good bonding. Besides, the magnitudes of the equivalent plastic strain for both flyer and base plates were higher than those reported values in the open literature that confirms successful welding.

A Study on Explosion Welding Defects of Large-Sized Plates

Study on defects of large-sized Ti/steel composite materials in explosive welding

Numerical Prediction and Control of Deformation and Residual Stress in Double-Sided Arc Welding of Large Pressure Hull

Prediction of Double-Sided Arc Welding Deformation Based on Dynamic Heat Distribution Model and TEP-FE Approach

Microstructure Simulation and Experiment for the Weak Weld Joint of a Domed Storage Tank during an Explosion Based on the Cellular Automaton Method

Explosive Welding of Multilayer Metal Plates

Investigating Welding Distortion of Thin-Plate Stiffened Panel Steel Structures by Means of Thermal Elastic Plastic Finite Element Method

Numerical Analysis on Optimizing Welding Sequence of Large-Sized Bottom Structure for Controlling Welding Distortion

Mechanism of Explosive Technique on Relieving Welding Residual Stresses

Effect of Welding Defects on Mechanical Properties of Welded Joints Subjected to Temperature

An experimental and numerical investigation on impact spot welding of metallic plates using gas mixture detonation technique

Prediction for Welding Deformation Reducing by Welding Sequence Optimization of Upper Plate

Influence of Initial Structural Dimensions of Plates on Welding Distortion

Research Progress on Welding Residual Stress and Deformation in Large or Complex Steel Structure

A New Analytical Model for Predicting the Welding Deformation of Large Welded Plates with Equivalent Moments

Microstructure and mechanical properties investigation of explosively welded titanium/copper/steel trimetallic plate

Comparative Study of Welding Deformation of a Stiffened Panel under Various Welding Procedures

Deformation and Spallation of Explosive Welded Steels under Gas Gun Shock Loading

Numerical Study on Mechanism of Explosive Welding

Prediction and Application of Welding Residual Deformation of Steel Sheets

Study on the Effects of Explosive Covering on Explosive Welding of Stainless Steel to Steel