Abstract:As the basic protective element, steel plate had attracted world-wide attention because of frequent threats of explosive loads. This paper reports the relationships between microscopic defects of Q345 steel plate under the explosive load and its macroscopic dynamics simulation. Firstly, the defect characteristics of the steel plate were investigated by stereoscopic microscope (SM) and scanning electron microscope (SEM). At the macroscopic level, the defect was the formation of cave which was concentrated in the range of 0–3.0 cm from the explosion center, while at the microscopic level, the cavity and void formation were the typical damage characteristics. It also explains that the difference in defect morphology at different positions was the combining results of high temperature and high pressure. Secondly, the variation rules of mechanical properties of steel plate under explosive load were studied. The Arbitrary Lagrange-Euler (ALE) algorithm and multi-material fluid-structure coupling method were used to simulate the explosion process of steel plate. The accuracy of the method was verified by comparing the deformation of the simulation results with the experimental results, the pressure and stress at different positions on the surface of the steel plate were obtained. The simulation results indicated that the critical pressure causing the plate defects may be approximately 2.01 GPa. On this basis, it was found that the variation rules of surface pressure and microscopic defect area of the Q345 steel plate were strikingly similar, and the corresponding mathematical relationship between them was established. Compared with Monomolecular growth fitting models (MGFM) and Logistic fitting models (LFM), the relationship can be better expressed by cubic polynomial fitting model (CPFM). This paper illustrated that the explosive defect characteristics of metal plate at the microscopic level can be explored by analyzing its macroscopic dynamic mechanical response.

Study on defects of large-sized Ti/steel composite materials in explosive welding

A Study on Explosion Welding Defects of Large-Sized Plates

Atomic Motion Behavior Calculation and Bonding Mechanism Analysis of Explosive Welding of High-Strength and High-Hardness Titanium Alloy Ti6Al4V/Aluminum Alloy 7075

Effect of Welding Defects on Mechanical Properties of Welded Joints Subjected to Temperature

Study on interface characteristics of TC4/7075 explosive welding based on molecular dynamics algorithm

Microstructure Simulation and Experiment for the Weak Weld Joint of a Domed Storage Tank during an Explosion Based on the Cellular Automaton Method

Investigating Welding Distortion of Thin-Plate Stiffened Panel Steel Structures by Means of Thermal Elastic Plastic Finite Element Method

Investigation of interfacial structure and dynamic mechanical behavior of titanium alloy laminated composites

Microstructure and mechanical properties investigation of explosively welded titanium/copper/steel trimetallic plate

Deformation and Spallation of Explosive Welded Steels under Gas Gun Shock Loading

Explosive Welding of Multilayer Metal Plates

Microstructure and characterization of Ti–Al explosive welding composite plate

Microscopic defects formation and dynamic mechanical response analysis of Q345 steel plate subjected to explosive load

Mechanism of Explosive Technique on Relieving Welding Residual Stresses

Comparative Study of Welding Deformation of a Stiffened Panel under Various Welding Procedures

Research on the interfacial microstructure of three-layered stainless steel/Ti/low-carbon steel composite prepared by explosive welding

The Microstructure and Mechanical Properties of TA1-Low Alloy Steel Composite Plate Manufactured by Explosive Welding

Research on Three Microcosmic Interface Defects of Titanium/Steel Laminates Manufactured by Explosive Welding

Research Progress on Welding Residual Stress and Deformation in Large or Complex Steel Structure

Study on the Effects of Explosive Covering on Explosive Welding of Stainless Steel to Steel

Experimental and Numerical Study on the Mechanical Behavior of Composite Steel Structure under Explosion Load