Abstract:In this paper, the impact spot welding of metallic plates was investigated both experimentally and numerically using a single-stage gas mixture detonation apparatus. The impact spot welding process was carried out on aluminum alloy and steel materials using rigid steel projectiles. In this process, the mixture of oxygen and acetylene was detonated in a combustion chamber to launch the projectile. The masses of flat- and spherical-nosed projectiles were 270 and 230 g, respectively. The impact velocity was measured in all experiments. The cross-sections of the weld spots were inspired by a scanning electron microscope to assess the quality of welding. For several experiments, wavy interfaces were observed showing there is a good bonding. For numerical simulation of the process, Abaqus/Explicit software was used and the deformation and failure mechanisms of impact spot-welded specimens were further investigated. The Johnson–Cook thermoplasticity model along with its failure model was utilized to predict the behavior of metallic materials. The numerical simulation results were in good agreement with those obtained from experiments in terms of the deformation mode and failure pattern. The propagation of the wave on the surface of the flyer plate was further studied. The results showed that the stress waves start from the center and propagate to the corners of the plate. To numerically evaluate the welding quality, two parameters of the shear stress at the collision point as well as the equivalent plastic strain for the flyer and target plates were obtained in the numerical simulation. The numerical results showed opposite directions of shear stress for flyer and base plates at the contact point, which can be used as proof for good bonding. Besides, the magnitudes of the equivalent plastic strain for both flyer and base plates were higher than those reported values in the open literature that confirms successful welding.

Explosive Welding of Multilayer Metal Plates

Explosive welding of Al alloys and high strength duplex stainless steel by controlling energetic conditions

Investigation on the interfacial microstructure and mechanical properties of the W-Cu joints fabricated by hot explosive welding

Experimental and numerical study on the mechanism of interlayer explosive welding

Experimental and Numerical Investigation on Fabricating Multiple Plates by an Energy Effective Explosive Welding Technique

Effects of Interlayer on the Interfacial Microstructures and Thermomechanical Kinetics of Explosive Welded 2A14 Aluminum Alloy-Niobium Composite

A Study on Explosion Welding Defects of Large-Sized Plates

Microstructure and mechanical properties investigation of explosively welded titanium/copper/steel trimetallic plate

Interface Strength and Structure of Explosive Welding Sainless Steel-Aluminum Clad

Investigation on microstructure and mechanical properties in explosive welded Mo–Cu/Cu interface

Research on the interfacial microstructure of three-layered stainless steel/Ti/low-carbon steel composite prepared by explosive welding

Fabrication and Performance Studies on Explosively Welded CuCrZr/316L Bimetallic Plate Applied in Extreme Environments

Upper Limit of Coated Amorphous Foils Explosive Welding

Copper plating on bonding properties of aluminium/steel explosive welded composite plate

Interfacial evolution mechanism of W/Cu explosive welding interface affected by preheating

Deformation and Spallation of Explosive Welded Steels under Gas Gun Shock Loading

Research on Explosive Welding of Aluminum Alloy to Steel with Dovetail Grooves

Study on the microstructure and mechanical properties of explosive welded 2205/X65 bimetallic sheet

An experimental and numerical investigation on impact spot welding of metallic plates using gas mixture detonation technique

Study on the Effects of Explosive Covering on Explosive Welding of Stainless Steel to Steel

Numerical Study on Mechanism of Explosive Welding