Abstract:Tungsten and water co-doped indium oxide (IWOH) films were deposited via a low-damage reactive plasma deposition method at room temperature followed by air atmosphere annealing. The structural, electrical, and optical properties of IWOH films with different water flow rates (FH2O) were systematically investigated before and after annealing. Despite the lower mobility (43.7 cm2/V) of IWOH films with high water flow rate (H-FH2O, FH2O ≥ 1.5 sccm) in the as-deposited state, it has increased to 65.2 cm2/V, which surpassed IWOH films with low water flow rate (L-FH2O, FH2O < 1.5 sccm) after annealing. Meanwhile, a significant increase in average optical transmittance from 80.9% to 88.8% and from 92.2% to 95.2% in the short wavelength of visible (350–500 nm) and near-infrared region (800–2500 nm), respectively, was obtained for H-FH2O films after annealing. The variation of the optical and electrical properties for IWOH films with different FH2O was attributed to the crystalline structure with a larger crystallite size and lower density of grain boundary. X-ray diffraction, scanning electron microscopy, and X-ray photoelectron spectroscopy analysis revealed that high water flow rate impeded crystallization of IWOH films during reactive plasma deposition, leading to an amorphous structure in the as-deposited state. After annealing, however, the H-FH2O films crystallized and exhibited larger grains than both tungsten-doped indium oxide (IWO) and L-FH2O films. The modified crystalline properties of IWOH films with larger grains hence reducing grain-boundary scattering, which was realized by H-FH2O and annealing treatment, gave rise to enhanced electrical properties without deteriorating optical properties.

Dependence of electrical and optical properties on thickness of tungsten-doped indium oxide thin films

Transparent conductive oxide thin films of tungsten-doped indium oxide

Tungsten Doped Indium Oxide Thin Films Deposited at Room Temperature by Radio Frequency Magnetron Sputtering

Development of Novel Tungsten-Doped High Mobility Transparent Conductive In2O3 Thin Films

Surface Pattern and Optical Properties of In-doped ZnO Thin Films by Hydrothermal Method

Tungsten-doped In2O3 Transparent Conductive Films with High Transmittance in Near-Infrared Region

Structural, Electrical, and Optical Properties of ZnInO Alloy Thin Films

Influence of film thickness on the texture, morphology and electro-optical properties of indium tin oxide films

Growth and Annealing of High Mobility Transparent Conductive Tungsten-Doped Indium Oxide Films

Amorphous Tungsten-Doped In2o3 Transparent Conductive Films Deposited at Room Temperature from Metallic Target

Properties of W-Mo Co-Doped In2O3 Thin Films Grown by Electron Beam Deposition

High mobility tungsten-doped indium oxide (IWO) deposited by room-temperature RF sputtering in pure argon plasma

Modification of work function by platinum and tungsten codoped indium oxide thin layer

Effects of Process Parameters on the Properties of W-doped In_2O_3 Transparent Conductive Thin Films Prepared by Dc Magnetron Sputtering

Effect of crystalline structure on optical and electrical properties of IWOH films fabricated by low-damage reactive plasma deposition at room temperature

Influence of Tungsten Doping on the Performance of Indium–Zinc–Oxide Thin-Film Transistors

Influence of thickness on crystallographic, stereometric, optoelectronic, and electrochemical characteristics of electron-beam deposited indium tin oxide thin films

Thickness Dependent Dislocation, Electrical and Optical Properties in Inn Films Grown by Mocvd

Effect of film thickness on the properties of indium tin oxide thin films

Investigation On Structural, Electrical And Optical Properties Of Tungsten-Doped Tin Oxide Thin Films

Preparation of Molybdenum-Doped Indium Oxide Thin Films Using Reactive Direct-Current Magnetron Sputtering