Abstract:Tungsten and water co-doped indium oxide (IWOH) films were deposited via a low-damage reactive plasma deposition method at room temperature followed by air atmosphere annealing. The structural, electrical, and optical properties of IWOH films with different water flow rates (FH2O) were systematically investigated before and after annealing. Despite the lower mobility (43.7 cm2/V) of IWOH films with high water flow rate (H-FH2O, FH2O ≥ 1.5 sccm) in the as-deposited state, it has increased to 65.2 cm2/V, which surpassed IWOH films with low water flow rate (L-FH2O, FH2O < 1.5 sccm) after annealing. Meanwhile, a significant increase in average optical transmittance from 80.9% to 88.8% and from 92.2% to 95.2% in the short wavelength of visible (350–500 nm) and near-infrared region (800–2500 nm), respectively, was obtained for H-FH2O films after annealing. The variation of the optical and electrical properties for IWOH films with different FH2O was attributed to the crystalline structure with a larger crystallite size and lower density of grain boundary. X-ray diffraction, scanning electron microscopy, and X-ray photoelectron spectroscopy analysis revealed that high water flow rate impeded crystallization of IWOH films during reactive plasma deposition, leading to an amorphous structure in the as-deposited state. After annealing, however, the H-FH2O films crystallized and exhibited larger grains than both tungsten-doped indium oxide (IWO) and L-FH2O films. The modified crystalline properties of IWOH films with larger grains hence reducing grain-boundary scattering, which was realized by H-FH2O and annealing treatment, gave rise to enhanced electrical properties without deteriorating optical properties.

Amorphous Tungsten-Doped In2o3 Transparent Conductive Films Deposited at Room Temperature from Metallic Target

Tungsten-doped In2O3 Transparent Conductive Films with High Transmittance in Near-Infrared Region

Tungsten Doped Indium Oxide Thin Films Deposited at Room Temperature by Radio Frequency Magnetron Sputtering

Transparent conductive oxide thin films of tungsten-doped indium oxide

Preparation and Properties of Tungsten-Doped Indium Oxide Thin Films

Development of Novel Tungsten-Doped High Mobility Transparent Conductive In2O3 Thin Films

Changes in the structural and electrical properties of vacuum post-annealed tungsten- and titanium-doped indium oxide films deposited by radio frequency magnetron sputtering

Influence of Oxygen Partial Pressure on Surface Morphology, Electrical and Optical Properties of IWO Film

High Carrier Mobility Tungsten-Doped Indium Oxide Films Prepared by Reactive Plasma Deposition in Pure Argon and Post Annealing

Fabrication and Photoelectric Properties of Tungsten-Doped Indium Oxide Films

High mobility tungsten-doped indium oxide (IWO) deposited by room-temperature RF sputtering in pure argon plasma

Effects of Dopant Content on Optical and Electrical Properties of In2o3: W Transparent Conductive Films

Growth and Annealing of High Mobility Transparent Conductive Tungsten-Doped Indium Oxide Films

Improvement of Electrochromic Performance by Embedding ITO Nanocrystals in Amorphous WO3 Film

Amorphous Indium Tin Oxide Films Deposited on Flexible Substrates by Facing Target Sputtering at Room Temperature

Atomic Oxygen Irradiation Resistance of Transparent Conductive Oxide Thin Films

The Effects of RF Power on the Optical and Electrical Properties of Transparent Conductive Hf-doped In2O3 Thin Films

Effect of crystalline structure on optical and electrical properties of IWOH films fabricated by low-damage reactive plasma deposition at room temperature

Effects of Process Parameters on the Properties of W-doped In_2O_3 Transparent Conductive Thin Films Prepared by Dc Magnetron Sputtering

Transparent conductive In2O3:Mo thin films prepared by reactive direct current magnetron sputtering at room temperature

Research on Surface Modification and Infrared Emissivity of In2O3: W Thin Films