Abstract:Finite element analyses of oxygen diffusion at the grain level have been carried out for a polycrystalline nickel-based superalloy, aiming to quantify the oxidation damage under surface oxidation conditions at high temperature. Grain microstructures were considered explicitly in the finite element model where the grain boundary was taken as the primary path for oxygen diffusion. The model has been used to simulate natural diffusion of oxygen at temperatures between 650∘C and 800∘C, which are controlled by the parabolic oxidation rate and oxygen diffusivity. To study the effects of mechanical stress on oxygen diffusion, a sequentially coupled deformation-diffusion analysis was carried out for a generic specimen geometry under creep loading condition using a submodeling technique. The material constitutive behavior was described by a crystal plasticity model at the grain level and a unified viscoplasticity model at the global level, respectively. The stress-assisted oxygen diffusion was driven by the gradient of hydrostatic stress in terms of pressure factor. Heterogeneous deformation presented at the grain level imposes a great influence on oxygen diffusion at 750∘C and above, leading to further penetration of oxygen into the bulk material. Increased load level and temperature enhance oxygen concentration and penetration within the material. At 700∘C and below, mechanical loading seems to have negligible influence on the oxygen penetration because of the extremely low values of oxygen diffusivity and pressure factor. In the case of an existing surface microcrack, oxygen tends to accumulate around the crack tip due to the high stress level presented near the crack tip, leading to localized material embrittlement and promotion of rapid crack propagation.

Modeling of Oxidation Kinetics of Y-Doped Fe–Cr–Al Alloys

Oxidation Mechanism of Three Fe-Al Alloys with and Without Addition of 0.1 At% Yttrium at 800 °C

Size Effects on Dissolution Kinetics of Y-Enriched Precipitates in FeCrAlY Alloys During High-Temperature Oxidation

Effect of Grain Size on the Oxidation of Fe–13Cr–5Ni Alloy at 973K in Ar–21vol%O2

A comparative study on the oxidation behavior of Y-, Hf- and YHf-doped NiCoCrAl alloys: effect of reactive elements

Oxidation behavior of Y 0.1 -doped FeCoNiAlCrB high-entropy alloy

A theoretical model and phase field simulation on the evolution of interface roughness in the oxidation process

Unraveling the oxidation mechanism of Y-doped AlCoCrFeNi high-entropy alloy at 1100 °C

Electronic-scale assessment of high-temperature oxidation mechanisms in a novel Fe-based alloy

Unraveling the oxidation mechanism of an AlCoCrFeNi high-entropy alloy at 1100 °C

Interdiffusional Degradation of Oxidation‐resistant Aluminide Coatings on Fe‐base Alloys

Modeling Selective Intergranular Oxidation of Binary Alloys

Modeling of Oxygen Diffusion Along Grain Boundaries in a Nickel-Based Superalloy

Modeling Oxidation of AlCoCrFeNi High-Entropy Alloy Using Stochastic Cellular Automata

High-Temperature Oxidation Properties and Microstructural Evolution of Nanostructure Fe-Cr-Al ODS Alloys

Reactive-element Effect of Electrodeposited Y2O3 Oxide Films on the Oxidation of Fe?25Cr and Fe?25Cr?10Al Alloys

Effect of Grain Size on Oxidation Behavior of Fe-40ni-15cr Alloys

Investigation of breakaway oxidation kinetics of nickel-base single crystal superalloys: Modeling and experiments

Modeling of Θ → Α Alumina Lateral Phase Transformation with Applications to Oxidation Kinetics of NiAl-based Alloys

Modeling of Growth Stress Gradient Effect on the Oxidation Rate at High Temperature

The Influence of FeO on the Reaction between Fe–Al–Ca Alloy and Al2O3–CaO–FeO Oxide during Heat Treatment at 1473 K