Abstract:A novel micro-electromechanical systems inertial switch based on non-silicon surface micromachining technology has been designed, fabricated and characterized in the present work. Compared with the traditional inertial switch, a compliant cantilever beam as a stationary electrode has been proposed to prolong the contact time, which can realize sufficient elastic deformation during the contact between the electrodes. The dynamic contact process is analyzed theoretically and the corresponding mechanical impact mechanism is also explained. To investigate the contact-enhancing mechanism of the cantilever beam, the switch applied half-sine acceleration with various amplitudes in the sensitive direction is simulated with ANSYS software. The dynamic simulation results confirm the contact-enhancing mechanism described by the theoretical analysis and it is shown that the contact time (i.e., the switch-on time) can be prolonged effectively by utilizing the elastic deformation of the cantilever beam and increased with the applied accelerations. The inertial switch is successfully fabricated by electroplating and sacrificial layer processes technologies. The prototype has been characterized by dropping hammer experiment. The test results indicate that the contact effect is improved significantly and the contact time is ∼80 µs under the 297 g acceleration, and the maximum value is ∼410 µs for the 672 g acceleration amplitude, which is in general accordance with the simulated results. The mechanical contact between the cantilever beam and the proof mass is evaluated following thousands of impacts. The scanning electron micrographs of the contact surfaces indicate that the all-metal switch still keeps a good mechanical property after suffering the hot contact, and the contact resistance is also stable.

Near-Zero Curvature Fabrication of Miniaturized Micromechanical Ni Switches Using Electron Beam Cross-Linked Pmma

Switching Characteristics of Electrostatically Actuated Miniaturized Micromechanical Metallic Cantilevers

Fabrication of A Nanoelectromechanical Switch Using A Suspended Carbon Nanotube

Nanoelectromechanical Switch with Low Voltage Drive

Nanoelectromechanical Switches with Vertically Aligned Carbon Nanotubes

A laterally-driven micromachined inertial switch with a compliant cantilever beam as the stationary electrode for prolonging contact time

Sub-0.3 volt amorphous metal WNx based NEMS switch with 8 trillion cycles

Lorentz Force-Actuated Bidirectional Nanoelectromechanical Switch with an Ultralow Operation Voltage

Fabrication of Carbon Nanotubes on Interdigitated Metal Electrode for Switchable Nanophotonic Devices

"Cnt-Polymer" Composite-Film As a Material for Microactuators

Study on opto-thermal drive micro-switch fabricated based on LIGA technology

Low-voltage Micromachining-Based Scalable Optical Switch

Micro-Fabricated bi-stable Mechanical Switch Actuated by a Single Thermal Actuator

Fabrication of a Micromachined Capacitive Switch Using the CMOS-MEMS Technology

Fabrication of Electromechanical Switch Using Interconnected Single-Walled Carbon Nanotubes

Low Voltage, High Speed and Small Area In-Plane MEMS Switch

Study of Fabrication Process of A Micro-Electrostatic Switch and Its Application to A Micromechanical V-F Converter

A Planar Single-Actuator Bi-Stable Mechanical/Electrical Switch

A Large Scale Fabrication of Graphene Based Nano-electromechanical Contact Switches With Ultra-low Pull-in Voltage

A Novel Miniature Optical Switch With Double Vertical Micromirrors Driven By Piezoelectric Cantilever

Single-Atom Switches and Single-Atom Gaps Using Stretched Metal Nanowires.