Abstract:As HDS catalysts, the supported catalysts including oxide state Mo, Co–Mo and sulfide state Mo on carbon nanotube (CNT) were prepared, while the corresponding supported catalysts on γ-Al2O3 were prepared as comparison. Firstly, the dispersion of the active phase and loading capacity of Mo species on CNT was studied by XRD and the reducibility properties of Co–Mo catalysts in oxide state over CNTs were investigated by TPR while the sulfide Co–Mo/CNT catalysts were characterized by XRD and LRS techniques. Secondly, the activity and selectivity of hydrodesulfurization (HDS) of dibenzothiophene with Co–Mo/CNT and Co–Mo/γ-Al2O3 were studied. It has been found that the main active molybdenum species in the oxide state MoO3/CNT catalysts were MoO2, rather than MoO3 as generally expected. The maximum loading before formation of the bulk phase was lower than 6%m (calculated in MoO3). The TPR studies revealed that that active species in oxide state Co–Mo/CNT catalysts were more easily reduced at relatively lower temperatures in comparison to those in Co–Mo/γ-Al2O3, indicating that the CNT support promoted the reduction of active species. Among 0–1.0 Co/Mo atomic ratio on Co–Mo/CNT, 0.7 has the highest reducibility. It shows that the Co/Mo atomic ratio has a great effect on the reducibility of active species on CNT and their HDS activities and that the incorporation of cobalt improved the dispersion of molybdenum species on CNT and mobilization. It was also found that re-dispersion could occur during the sulfiding process, resulting in low valence state Mo3S4 and Co–MoS2.17 active phases. The HDS of DBT showed that Co–Mo/CNT catalysts were more active than Co–Mo/γ-Al2O3 and the hydrogenolysis/hydrogenation selectivity of Co–Mo/CNT catalyst was also much higher than Co–Mo/γ-Al2O3. For the Co–Mo/CNT catalysis system, the catalyst with Co/Mo atomic ratio of 0.7 showed the highest activity, whereas, the catalyst with Co/Mo atomic ratio of 0.35 was of the highest selectivity.

MCM-41-supported Co-Mo Catalysts for Deep Hydrodesulfurization of Light Cycle Oil

Catalytic Characteristics of Active Corner Sites in CoMoS Nanostructure Hydrodesulfurization – A Mechanism Study Based on DFT Calculations

Mesoporous Carbon Supported Co-Mo and Ni-Mo Catalysts for Hydrodesulfurization

Synthesis of alumina-nitrogen-doped carbon support for CoMo catalysts in hydrodesulfurization process

Construction of High Content CoMoS Active Sites Through the Combination of Co 5 Mo 10 Molecular Precursors and Inert Carbon Matrix Support for Deep Hydrodesulfurization

Hydroisomerization of Model FCC Naphtha over Sulfided Co(Ni)–Mo(W)/MCM-41 Catalysts

Synergy effect of boron and cobalt in B2O3-SBA-15-(Co)Mo catalyst for efficient hydrodesulfurization of liquid fuels

Progress of Catalysts for Deep Hydrodesulfurization of Fuels

Electronic structure regulation of CoMoS catalysts by N, P co-doped carbon modification for effective hydrodesulfurization

MOF-derived CoP/C catalyst for efficient dibenzothiophene hydrodesulfurization

Synergistic effect between CoS x and MoS 2 at the micrometer scale: Considerable promotion of the hydrodesulfurization of DBT

Preparation of Co-Mo/γ-Al2O3 catalyst and the catalytic hydrogenation effects on coal-related model compounds

Synthesis of cube MgO@AC and catalytic performance of its supported CoMo for hydrodesulfurization of 4,6-dimethyldibenzothiophene

Hydrodesulfurization of Gas Condensate containing Di-Sulfide Oil: Catalyst synthesis and evaluation

Improving Both the Activity and Selectivity of CoMo/δ-Al 2 O 3 by Phosphorous Modification for the Hydrodesulfurization of Fluid Catalytic Cracking Naphtha

Hydrodesulfurization of Thiophene in n-Heptane Stream Using CoMo/SBA-15 and CoMo/AlSBA-15 Mesoporous Catalysts

Influence of Active Phase Structure of CoMo/Al2O3 Catalyst on the Selectivity of Hydrodesulfurization and Hydrodearomatization

Enhanced hydrodesulfurization activity of thiophene over hollow tubular CoMo unsupported catalysts

States of Carbon Nanotube Supported Mo-Based HDS Catalysts

Catalysis by Sulfides: Advanced IR/CO Spectroscopy for the Identification of the Most Active Sites in Hydrodesulfurization Reactions

Enhancement of hydrotreating activity of oil-soluble CoMo6 heteropolyacid for 4,6-dimethyldibenzothiophene and vacuum residue by controlling sulfurization degree