Abstract:Co-Mo/γ-Al2O3 bimetallic catalyst was prepared by incipient wetness impregnation and the physicochemical properties were obtained by a series of characterization methods. The active components are mainly MoS2 and Co-Mo-S existing on γ-Al2O3, the support. Meanwhile, the activity of catalyst in hydroconversion of four coal-related model compounds (CRMCs), dibenzyl ether, furan, thiophene and quinoline, was investigated. Hydroconversion products were analyzed by gas chromatography/mass spectrometry (GC/MS) and the possible reaction pathways were proposed according to the GC/MS data. Oxygen was removed from dibenzyl ether via the direct cleavage of Calk-O bridge bond to produce benzylium cation followed by the combination with H− to generate toluene. The hydroconversion of furan can be realized by the direct cleavage of Car-O bond and direct hydrogenation, respectively. For thiophene, H+ directly transferred to sulfur atom, leading to the cleavage of Car-S bond to produce H2S and 1,3-butadiene, which abstracted active hydrogen to yield butane. Another indirect desulfurization pathway for thiophene is hydrogenating to form tetrahydrothiophene and C–S bond cracking to produce butane. Hydroconversion of quinoline started with either N-ring or benzene ring, and the first one was the main pathway.

What problem does this paper attempt to address?

The main problem that this paper attempts to solve is to effectively remove heteroatoms in coal - based oil by preparing Co - Mo/γ - Al₂O₃ bimetallic catalysts and studying their catalytic hydrogenation effects on coal - related model compounds (CRMCs). Specifically, the paper focuses on the following points: 1. **Preparation and Characterization of Catalysts**: A series of Co - Mo/γ - Al₂O₃ bimetallic catalysts with different Mo/Co molar ratios were prepared by the impregnation method, and the physicochemical properties of the catalysts were studied in detail by various characterization methods (such as BET, NH₃ - TPD, SEM, TEM - EDS, XPS and XRD). 2. **Study of Catalytic Activity**: Four coal - related model compounds (CRMCs), namely, diphenyl ether, furan, thiophene and quinoline, were selected to study the hydrogenation conversion effects of these compounds under the action of Co - Mo/γ - Al₂O₃ catalysts. The hydrogenation products were analyzed by gas chromatography/mass spectrometry (GC/MS), and possible reaction paths were proposed. 3. **Analysis of Reaction Paths**: - **Hydrodeoxygenation of Diphenyl Ether**: Phenylmethyl cations are mainly generated by the direct cleavage of C - O bridge bonds, and then combined with H/C₀ to form toluene. - **Hydrogenation Conversion of Furan**: It can be achieved through two pathways: direct cleavage of C - O bonds and direct hydrogenation. - **Hydrodesulfurization of Thiophene**: H⁺ is directly transferred to the sulfur atom, resulting in the cleavage of C - S bonds to generate H₂S and 1,3 - butadiene, and the latter is further hydrogenated to form butane. Another indirect desulfurization pathway is to first form tetrahydrothiophene and then generate butane through C - S bond cleavage. - **Hydrogenation Conversion of Quinoline**: It can start from the N - ring or the benzene ring, among which the hydrogenation of the N - ring is the main pathway. 4. **Optimization of Reaction Conditions**: The effects of Mo/Co molar ratio, reaction temperature, reaction time and initial hydrogen pressure on the catalytic hydrogenation conversion of CRMCs were studied, and the optimal reaction conditions were determined. Through these studies, the paper provides a theoretical basis for the efficient and targeted conversion and removal of heteroatoms in coal.

Preparation of Co-Mo/γ-Al2O3 catalyst and the catalytic hydrogenation effects on coal-related model compounds

Catalytic Characteristics of Active Corner Sites in CoMoS Nanostructure Hydrodesulfurization – A Mechanism Study Based on DFT Calculations

Multinuclear solid-state NMR characterization of the coke on Mo/Hβ-Al2O3 catalyst for olefin metathesis

Multinuclear Solid-State NMR Characterization of the Coke on Mo/Hβ-Al_2O_3 Catalyst for Olefin Metathesis

Effect of Ni/Mo on the preparation of non-loaded NiMoSx catalysts and the hydrogenation performance of coal tar

Mesoporous Carbon Supported Co-Mo and Ni-Mo Catalysts for Hydrodesulfurization

Hydrogenation of coal tar on NiMoP/γ-Al2 O3 catalyst

The effects of Fe2O3 and MoS2 on the catalytic activation pathway of hydrogen sources during direct coal liquefaction

Influence of Carbonization Conditions on Structural and Surface Properties of K-Doped Mo2C Catalysts for the Synthesis of Methyl Mercaptan from CO/H2/H2S

COx hydrogenation to methanol and other hydrocarbons under mild conditions with Mo3S4@ZSM-5

Synthesis of alumina-nitrogen-doped carbon support for CoMo catalysts in hydrodesulfurization process

Hydroisomerization of Model Naphtha over Sulfided Co-Mo/SBA-15 Catalyst

Study on the preparation of TiO2-Al2 O3 composite support and its application in Co-Mo/TiO2-Al2 O3 catalyst for hydro-desulfurization

States of Carbon Nanotube Supported Mo-Based HDS Catalysts

Electronic structure regulation of CoMoS catalysts by N, P co-doped carbon modification for effective hydrodesulfurization

Effect of Co Additive on Formation of Coke Deposits in Methane Dehydro-Aromatization over Mo/HZSM-5 Catalyst

Synthesis of MoSs/Al2O3 Composites and Its Application in Preparation of Hydrogenation Catalysts

Hydrogenation of CO2 on MoO3/Al2O3 and γ-Al2O3

Highly Selective Conversion of COx to C2-4 Hydrocarbons over MoSx@HSSZ-39 Catalyst

Synthesis of loaded monolayer MoS 2 catalysts and effect on coal tar hydrotreating performance

Of Model Compounds with Catalysts of NiW / Al 2 O 3 and NiWP / Al 2 O 3 to Simulate Low Temperature Coal Tar Oil