Abstract:It is well-known that a fine dispersed rubber phase in thermoplastic vulcanizates (TPVs) is a key to obtain good mechanical properties and high elasticity of TPV products. Previous studies reported that the rubber nanodroplets formed during shearing blending can transform into rubber nanoparticles by in situ rapid crosslinking and these rubber nanoparticles spontaneously form agglomerates dispersed in a plastic matrix during dynamic vulcanization (DV). However, important influencing factors on the formation of rubber nanoparticles and their agglomeration during DV have not been reported yet. In this study, the coupling effect of the molecular weight (MW) of polypropylene (PP) and crosslinking kinetics including the crosslinking rate (CR) and crosslinking degree (CD) on the size of ethylene propylene diene monomer (EPDM) rubber nanoparticles and their agglomerates in EPDM/PP TPVs was systematically studied for the first time. The minimum diameter of EPDM nanodroplets was theoretically calculated by using the critical break-up law of viscoelastic melts for the blend with high MW PP or the critical capillary equation for the blend with low MW PP, and the real size of the EPDM nanoparticles was experimentally verified. Interestingly, the results show that the lower MW of the PP phase, lower CD and higher CR contribute to the formation of smaller rubber nanoparticles, whereas the higher MW of the PP phase and higher CD of the rubber phase contribute to the formation of smaller rubber nanoparticle agglomerates. This study provides guidance to optimize the microstructure of EPDM/PP TPVs for the preparation of high-performance TPV products.

Study on PP/EPDM Blend Toughened by Dynamic Vulcanization

Mechanical properties, morphological structure, and thermal behavior of dynamically photocrosslinked PP/EPDM blends

PP/EPDM-based Dynamically Vulcanized Thermoplastic Olefin with Zinc Dimethacrylate: Preparation, Rheology, Morphology, Crystallization and Mechanical Properties

Highly Toughened Polypropylene/ethylene–propylene-Diene Monomer/zinc Dimethacrylate Ternary Blends Prepared Via Peroxide-Induced Dynamic Vulcanization

Mechanical Properties and Thermal Behaviors of Dynamically Photocrosslinked PP/EPDM Blends

Study of Dynamically Cured PP/MAH-g-EPDM/epoxy Blends

Mechanical properties and structural characteristics of dynamically photocrosslinked PP/EPDM blends

Dynamically photocrosslinking of polypropylene/EPDM blends as a thermoplastic elastomer

Effect of Additives on the Morphology Evolution of EPDM/PP TPVs During Dynamic Vulcanization in a Twin-Screw Extruder

Study on mechanical properties of dynamically cured PP/epoxy resin blends

Effects of Dynamic Crosslinking on Crystallization, Structure and Mechanical Property of Ethylene-Octene Elastomer/EPDM Blends

Study on Rheological Properties of Reactive PP/EPDM Blends

In Situ Reactive Compatibilization and Reinforcement of Peroxide Dynamically Vulcanized Polypropylene/ethylene‐propylene‐diene Monomer Tpv by Zinc Dimethacrylate

Effect of Rubber Nanoparticle Agglomeration on Properties of Thermoplastic Vulcanizates During Dynamic Vulcanization.

Brittle-tough transition in PP/EPDM blends: effects of interparticle distance and temperature

Morphological structure of dynamically vulcanized thermoplastic elastomer of ethylene propylene diene monomer/polypropylene

Coupling Effect of Molecular Weight and Crosslinking Kinetics on the Formation of Rubber Nanoparticles and Their Agglomerates in EPDM/PP TPVs During Dynamic Vulcanization.

Dynamically Vulcanized Ethylene Propylene Diene Terpolymer/nylon Thermoplastic Elastomers

Study on the Cooperative Toughening of Dynamic Vulcanized PP/EPDM/nano-SiO2 Composites with Double Particles

Study on the Preparation and Properties of POE/PP Dynamic Vulcanized Thermoplastic Elastomers with Low Degree of Hardness

The Morphology and Property of Ultra‐fine Full‐vulcanized Acrylonitrile Butadiene Rubber Particles/epdm Blends