Abstract:To better understand the passive torsional motion and to quantify the torsional motion of an insect, we developed a new scanning beam method that can measure with high resolution the variation in both the torsion angle and shape of an insect wing during pure Rapping motion. This new method is based on the conventional principle used in a laser beam displacement probe with a position detector, but introduces the use of an acousto-optic deflector, which enables us to pass the scanning laser beam over the wing. Therefore, by measuring the relative displacement between the beam spots on the wing, we can determine the passive variation in both the torsion angle and shape of an insect wing with high resolution. According to the waveform supplied to the acousto-optic deflector we define both a two-point scanning method, which we use to measure the variation in torsion angle, and a multipoint scanning method, which we use to measure the variation in shape. We apply these methods to a dragonfly wing at different flapping frequencies, and compare the results with those determined using a high-speed video camera. The good agreement between the two methods shows that the scanning beam method can be effectively applied in the field of biomechanics to study the torsion angle variation and shape variation of an insect wing. (C) 1996 Society of Photo-Optical instrumentation Engineers.

Angle-compensation Sensor for Measuring the Shape of a Dragonfly Wing

High‐resolution Method for Measuring the Torsional Deformation of a Dragonfly Wing by Combining a Displacement Probe with an Acousto‐optic Deflector

Simultaneous Measurement of the Shape and Thickness of a Dragonfly Wing

Measurement of the Displacement of Diffuse Surface with Low Reflectivity Using Angle Compensation Technique

Small Angular Displacement Measurement Based on an Autocollimator and a Common-Path Compensation Principle.

Research on high-speed and non-contact angle detection based on laser measurement

Roll angle measurement based on common path compensation principle

A New Method for Measuring the Thickness and Shape of A Thin Film Simultaneously by Combining Interferometry and Laser Triangulation

Measuring the Body Position, Attitude and Wing Deformation of a Free-Flight Dragonfly by Combining a Comb Fringe Pattern with Sign Points on the Wing

Two-dimensional, Noncontact Measurement of the Natural Frequencies of Dragonfly Wings Using a Quadrant Position Sensor

Measurement of the Flapping Angle and Torsional Angle of a Dragonfly Wing Using Fringe Projection Method

Measuring the Camber Deformation of A Dragonfly Wing Using Projected Comb Fringe

Ultra-sensitive angle sensor based on laser autocollimation for measurement of stage tilt motions

Measurement on Camber Deformation of Wings of Free-flying Dragonflies and Beating-flying Dragonflies

Subnanometer Resolution Displacement Sensor Based on a Grating Interferometric Cavity with Intensity Compensation and Phase Modulation

Two-Colour Compensation Method for Measuring Unsteady Vertical Force of an Insect in A Wind Tunnel

Measuring Wing Kinematics, Flight Trajectory and Body Attitude During Forward Flight and Turning Maneuvers in Dragonflies

Scanning Beam Collimation Method for Measuring Dynamic Angle Variations Using an Acousto‐optic Deflector

A Scanning Projected Line Method for Measuring a Beating Bumblebee Wing

A compact 2D micro-angle sensor

2D Micro-Angle Sensor Based on Laser Autocollimation