Abstract:Nb3Sn conductors are important candidates for high-field magnets for particle accelerators, and they continue to be widely used for many laboratory and NMR magnets. However, the critical current density, Jc, of present Nb3Sn conductors declines swiftly above 12-15T. State-of-the-art Ta- and Ti-doped strands exhibit upper critical field, Hc2, values of 24-26.5T (4.2K) and do not reach the FCC target Jc, which serves as the present stretch target for Nb3Sn development. As recently demonstrated, to meet this goal requires enhanced vortex pinning but an independent and supplementary approach is to significantly enhance Hc2. In this study, we have arc-melted multiple Nb alloys with added Hf, Zr, Ta and Ti and drawn them successfully into monofilament wires to investigate the possibilities of Hc2 enhancement through alloying. Hc2(T) was measured for all samples in fields up to 16T and some up to 31T. We have found that all alloys show good agreement with the standard Werthamer, Helfand, and Hohenberg (WHH) fitting procedure without the need to adjust the paramagnetic limitation parameter (alpha) and spin-orbit scattering parameter (lambda_so). The evaluation of dHc2/dT near Tc, which is proportional to the electronic specific heat coefficient (gamma) and the normal state resistivity (rho_n), allows a better understanding of the induced disorder introduced by alloying in the A15 phase. So far, we have observed that Hf alloying of pure Nb can enhance Hc2(0) by 3-4T to 28T, while adding just 1 at. %Hf or Zr into a Nb4Ta base alloy can raise Hc2(0) to 31T. Very importantly we find that Hf and Zr raise the alloy recrystallization temperature above the usual A15 reaction temperature range of 650°C-750°C, thus ensuring denser A15 phase nucleation in the Nb alloy grain boundaries, possibly leading to a more homogeneous A15 phase Sn content and refined A15 grain size. The potential for...

A15 PHASE GROWTH KINETICS OF INTERNAL-Sn Nb3 Sn SUPERCONDUCTING WIRES

Formation and upper critical fields of the two distinct A15 phases in the subelements of Powder-In-Tube Nb3Sn wires

Minimum Interface Misfit Criterion for the Precipitation Morphologies of TCP Phases in a Ni-based Single Crystal Superalloy

Preparation of Nb 3 Al Superconductor by Powder Metallurgy and Effect of Mechanical Alloying on the Phase Formation

Preparation of Nb3al by High-Energy Ball Milling and Superconductivity

Unveiling the nucleation and growth of Zr oxide precipitates of internally oxidized Nb3Sn superconductors

X-Ray Absorption Spectroscopy to Investigate Precipitated Oxides in Nb 3 Sn Wires With an Internal Oxygen Source

Diffusion in A15 Nb3Sn: An atomistic study

Influence of Nb Alloying on Nb Recrystallization and the Upper Critical Field of Nb3Sn

The evolution of Bi-2223 phase and liquid phase during the first heat treatment in Bi-2223/Ag superconducting tapes

Improved critical current density of Cu-doped Nb3Al wire through optimized Rapid-Heating Quenching and Transformation method

Effect of Hf Addition to Nb on Nb 3 Sn Grain Morphology Under High Sn Diffusion Driving Force

Investigation of Intermediate Phases and Phase Transition Temperature of Α/β in the Zr-Sn-Nb-Fe Alloy

PREPARATION OF Bi2Sr2Ca1Cu2Ox SUPERCONDUCTING FILMS ON Ag WIRES BY DIP-COATING METHOD

A Review of the Properties of Nb3Sn and Their Variation with A15 Composition, Morphology and Strain State

Thermal Conductivity of Industrial Nb3Sn Wires Fabricated by Various Techniques

Nb/Sn Liquid-Solid Reactive Diffusion Couples and Their Application to Determination of Phase Equilibria and Interdiffusion Coefficients of Nb-Sn Binary System

Effect of Cu doping on properties of RHQT processed powder in tube Nb3Al wires

Experimental verification of the temperature and strain dependence of the critical properties in Nb/sub 3/Sn wires

Amorphous-to-Cu51Zr14phase Transformation in Cu60Ti20Zr20alloy

Study on the Relationship Between TCP Phase and AlN Phase in a Fourth-Generation Single-Crystal Superalloy