Abstract:In this paper, we present a systematic study of the as-cast and heat-treated microstructures of three refractory metal intermetallic composites based on Nb (i.e., RM(Nb)ICs), namely the alloys EZ2, EZ5, and EZ6, and one RM(Nb)IC/RCCA (refractory complex concentrated alloy), namely the alloy EZ8. We also examine the hardness and phases of these alloys. The nominal compositions (at.%) of the alloys were Nb-24Ti-18Si-5Hf-5Sn (EZ2), Nb-24Ti-18Si-5Al-5Hf-5Sn (EZ5), Nb-24Ti-18Si-5Cr-5Hf-5Sn (EZ6), and Nb-24Ti-18Si-5Al-5Cr-5Hf-5Sn (EZ8). All four alloys had density less than 7.3 g/cm3. The Nbss was stable in EZ2 and EZ6 and the C14-NbCr2 Laves phase in EZ6 and EZ8. In all four alloys, the A15-Nb3X (X = Al,Si,Sn) and the tetragonal and hexagonal Nb5Si3 were stable. Eutectics of Nbss + Nb5Si3 and Nbss + C14-NbCr2 formed in the cast alloys without and with Cr addition, respectively. In all four alloys, Nb3Si was not formed. In the heat-treated alloys EZ5 and EZ8, A15-Nb3X precipitated in the Nb5Si3 grains. The chemical compositions of Nbss + C14-NbCr2 eutectics and some Nb5Si3 silicides and lamellar microstructures corresponded to high-entropy or complex concentrated phases (compositionally complex phases). Microstructures and properties were considered from the perspective of the alloy design methodology NICE. The vol.% Nbss increased with increasing ΔχNbss. The hardness of the alloys respectively increased and decreased with increasing vol.% of A15-Nb3X and Nbss. The hardness of the A15-Nb3X increased with its parameter Δχ, and the hardness of the Nbss increased with its parameters δ and Δχ. The room-temperature-specific strength of the alloys was in the range 271.7 to 416.5 MPa cm3g-1. The effect of the synergy of Hf and Sn, or Hf and B, or Hf and Ge on the macrosegregation of solutes, microstructures, and properties of RM(Nb)ICs/RCCAs from this study and others is compared. Phase transformations involving compositionally complex phases are discussed.

A Review of the Properties of Nb3Sn and Their Variation with A15 Composition, Morphology and Strain State

Comparative study on the strain-dependent mechanical and electronic properties of Nb<sub>3</sub>Al and Nb<sub>3</sub>Sn

Strain sensitivity and superconducting properties of Nb3Sn from first principles calculations

Peculiarities of niobium-based superconducting alloys in the light of crystal chemistry: A brief survey

Insight into structural, electronic, elastic and thermal properties of A15-type Nb3X (X = Si, Ge, Sn and Pb) compounds

Diffusion in A15 Nb3Sn: An atomistic study

Structural and electronic properties of superconducting Heusler alloy Ni$_{2}$Nb$_{1+x}$Sn$_{1-x}$: \textit{Ab initio} approach

Influence of Nb Alloying on Nb Recrystallization and the Upper Critical Field of Nb3Sn

Crystal growth, characterization and physical properties of PrNiSb3, NdNiSb3 and SmNiSb3

Coexistence of Superconductivity and Charge Density Wave Instability in A15-\ch{Nb3Sn}

Preparation of Nb 3 Al Superconductor by Powder Metallurgy and Effect of Mechanical Alloying on the Phase Formation

A Study of the Effects of Hf and Sn on the Microstructure, Hardness and Oxidation of Nb-18Si Silicide-Based Alloys-RM(Nb)ICs with Ti Addition and Comparison with Refractory Complex Concentrated Alloys (RCCAs)

Preparation of Nb3al by High-Energy Ball Milling and Superconductivity

Dirac surface states, multiorbital dimerization and superconductivity in Nb- and Ta-based A15 compounds

Synthesis of new high-entropy alloy-type Nb3 (Al, Sn, Ge, Ga, Si) superconductors

Selective thermal evolution of native oxide layer in Nb and Nb3Sn-coated SRF grade Nb: An in-situ angular XPS study

Experimental verification of the temperature and strain dependence of the critical properties in Nb/sub 3/Sn wires

Optimization of Magnetic Stability in Nb3Sn Materials Near Stoichiometric Composition

A review and prospects for Nb3Sn superconductor development

The role of copper in the formation of the Nb3Sn superconducting phase

First principles study of the structure and properties of Nb-Sn alloys under high pressure