Abstract:The original Johnson-Cook model's poor prediction of W90 alloy stress at high strain rate and high and low temperatures restricts research and utilization of this alloy. This study used a Split Hopkinson Pressure Bar (SHPB) device to conduct dynamic compression tests on W90 alloy over a temperature range of [-90°C,700°C] and analyze its mechanical behavior. We examined the material's different plastic phase characteristics at high and low temperatures and conducted microstructure research on impact test specimens. Then, we analyzed the stress-strain data from SHPB experiments and quasi-static compression tests on the classical Johnson-Cook model. The original Johnson-Cook model was calibrated using the stress-strain data from SHPB and quasi-static compression tests, and the modified Johnson-Cook model was established and verified. The results show that: low temperature significantly strengthens the material's stress, while increasing temperature thermal softening reduces stress; increasing strain rate increases the strain generated by the workpiece, causing faster strain hardening and thermal softening effects, resulting in higher and more stable stress; low temperature makes thicker grain boundaries, increasing plastic stress, and increasing strain rate also increases plastic stress, as well as making the material's grain boundaries thicker. The increase of strain rate makes the grain more dense, which will also show up in the increase of stress on the macroscopic level; the modified Johnson-Cook model in this paper has high agreement with experimental data, with a mean value of MAPE of only 1.85 %,which is 90.20 % lower than the traditional model, and the average value of the RMSE is 85.56 % lower than the traditional model. The modified model significantly outperforms the traditional model in predicting stress and better describes stress changes in W90 at different temperatures.

Development of A Material Constitutive for High-Rate Using A Combined Experiment/Computation Method

0610 A Comparative Study on Gao-Zhang and Johnson-Cook Constitutive Models

FE Realization of a Thermo-Visco-Plastic Constitutive Model Using VUMAT in ABAQUS/Explicit Program

The Role of Material Model in the Finite Element Simulation of High-Speed Machining of Ti6Al4V

Application of Numerical Simulation to SHPB Test to Investigate the Dynamic Compressive Behavior of Material with Failure

Constitutive Modelling of Plasticity of Fcc Metals under Extremely High Strain Rates

Modification of the Johnson-Cook relationship for AZ31 magnesium alloy at high strain rates

A Modified Johnson–Cook Constitutive Model and Its Application to High Speed Machining of 7050-T7451 Aluminum Alloy

A CONSTITUTIVE MODEL AND DATA FOR METALS SUBJECTED TO LARGE STRAINS, HIGH STRAIN RATES AND HIGH TEMPERATURES

Method of Finite Element Model Updating for Identifying the Parameters of Modified Johnson–Cook Constitutive Equation

On the Constitutive Models for Ultra-High Strain Rate Deformation of Metals

Research and Revise on Constitutive Equation of 7050-T7451 Aluminum Alloy in High Strain Rate and High Temperature Condition

Constitutive Model of Physical Simulation in High Speed Cutting for Al6061-T6

Identification of material parameters at high strain rates using ballistic impact tests and inverse finite element analysis

Modification of strain rate strengthening coefficient for Johnson-Cook constitutive model of Ti6Al4V alloy

Material characterization at high strain rate by Hopkinson bar tests and finite element optimization

A modified parallel-sided shear zone model for determining material constitutive law

High strain rate experiments and constitutive model for Q390D steel

Mechanical properties and JC constitutive modification of tungsten alloys under high strain rates and high/low temperatures

Physical Based Constitutive Model for the Prediction of Plastic Deformation of Fe‐Cr‐Ni Stainless Steel Under High Strain Rate

Modified Johnson-Cook Constitutive Model for Dynamic Compressive Behaviors of C250 Maraging Steel at Different Temperatures