Abstract:A series of tungsten-gradually doped diamond-like carbon (DLC) films with functionally graded interlayer were prepared using a hybrid technique of vacuum cathodic arc/magnetron sputtering/ion beam deposition. With ‘compositionally graded coating’ concept, the deposition of wear-resistant carbon-based films with excellent adhesion to metallic substrate was realized. In the films, a functionally graded interlayer with layer sequence of Cr/CrN/CrNC/CrC/WC was first deposited onto the substrate, and then, a DLC layer doped with gradually decreasing content of W was coated on. The W concentration gradient along depth of the film was tailored by adjusting the W target current and deposition time. The characterized results indicate that the microstructural, mechanical and tribological properties of these films show a significant dependence on the W concentration gradient. A high fraction of W atom in carbon matrix can promote the formation of sp2 sites and WC1−x nanoparticles. Applying this coating concept, strongly adherent carbon films with critical load exceeding 100N in scratch test were obtained, and no fractures or delaminations were observed at the end of the scratched trace. The hardness was found to vary from 13.28 to 32.13GPa with increasing W concentration. These films also presented excellent tribological properties, especially significantly low wear rate under dry sliding condition against Si3N4 ball. The optimum wear performance with friction coefficient of 0.19 and wear rate of 8.36×10−7 mm3/Nm was achieved for the tungsten-gradually doped DLC film with a graded W concentration ranging from 52.5% to 17.8%. This compositionally graded coating system might be a potentially promising candidate for wear-resistant carbon-based films in the demanding tribological applications.

W-Doped Dlc Films by Ibd and Ms

Tribological Behaviors of W-Doped DLC Films

Study on W Graded Doping Dlc Composite Films with Multicomponent Transition Layer

Effect of W-doping on the structure and properties of DLC films prepared by combining physical and chemical vapor deposition

Influence of Target Current on the Structure of Ti-Doped DLC Films

Influences of W Content and Friction Condition on the Tribological Properties of W-Doped DLC Coatings

Microstructure and Mechanical Properties of Dlc Films Doped with High Crystallinity Crn Nanoparticles

Microstructural, Mechanical and Tribological Properties of Tungsten-Gradually Doped Diamond-Like Carbon Films with Functionally Graded Interlayers

Further Improving the Mechanical and Tribological Properties of Low Content Ti-doped DLC Film by W Incorporating

States of W in diamond-like carbon coatings and its effects on hybrid structure and mechanical performance: Molecular dynamics simulations

Cr-doped DLC films in three mid-frequency dual-magnetron power modes

The Impact of Dopants (B, H) on the Mechanical Behavior and Tribological Performance of DLC Film under Water Lubrication

Investigation on Preparation and Properties of Thick DLC Film in Medium-Frequency Dual-Magnetron Sputtering

DLC Film Fabricated by a Composite Technique of Unbalanced Magnetron Sputtering and PIII.

Mechanical and tribological properties of non-hydrogenated DLC films synthesized by IBAD

Structure and Topographies of Diamond-Like Carbon Films Produced on Tungsten Pre-Implanted Stainless Steel Substrate by Plasma Immersion Ion Implantation and Deposition

Hydrogen-free DLC films fabricated using superimposed HiPIMS-DCMS deposition system: Bias voltage effects

Diamond-like Carbon Film Synthesized by Ion Beam Assisted Deposition and Its Tribological Properties

Influence of W Content on Microstructural, Mechanical and Tribological Properties of Sulfurized W-Doped Diamond-Like Carbon Coatings

Microstructure and properties of Mo doped DLC nanocomposite films deposited by a hybrid sputtering system

Improving the internal stress and wear resistance of DLC film by low content Ti doping