Abstract:The modeling of stator and rotor faults is the basis of the development of online monitoring techniques. To obtain reliable stator and rotor fault models, this paper focuses on dynamic modeling of the stator and rotor faults in real-time, which adopts a multiple-coupled-circuit method by using a winding function approach for inductance calculation. Firstly, the model of the induction machine with a healthy cage is introduced, where a rotor mesh that consists of a few rotor loops and an end ring loop is considered. Then, the stator inter-turn fault model is presented by adding an extra branch with short circuit resistance on the fault part of a stator phase winding. The broken rotor bar fault is then detailed by merging and removing the broken-bar-related loops. Finally, the discrete models under healthy and faulty conditions are developed by using the Tustin transformation for digital implementation. Moreover, the stator and rotor mutual inductances are derived as a function of the rotor position according to the turn and winding functions distribution. Simulations and experiments are performed on a 2.2-kW/380-V/50-Hz three-phase and four-pole induction motor to show the performance of the stator and rotor faults, where the saturation effect is considered in simulations by exploiting the measurements of a no load test. The simulation results are in close agreement with the experimental results. Furthermore, magnitudes of the characteristic frequencies of 2f1 in torque and (1 ± 2s)f1 in current are analyzed to evaluate the stator and rotor fault severity. Both indicate that the stator fault severity is related to the short circuit resistance. Further, the number of shorted turns and the number of continuous broken bars determines the rotor fault severity.

An Active Stator Temperature Estimation Technique for Thermal Protection of Inverter-Fed Induction Motors with Considerations of Impaired Cooling Detection

A Remote and Sensorless Stator Winding Resistance Estimation Method for Thermal Protection of Soft-Starter-Connected Induction Machines

A DC Signal Injection-Based Thermal Protection Scheme for Soft-Starter-Connected Induction Motors

A Remote and Sensorless Thermal Protection Scheme for Soft-Starter-Connected Induction Motors

Active Stator Winding Thermal Protection for AC Motors

A Nonintrusive Thermal Monitoring Method for Induction Motors Fed by Closed-Loop Inverter Drives

Practical implementation of a remote and sensorless stator resistance-based thermal protection method

Modeling and Evaluation of Stator and Rotor Faults for Induction Motors

Improving Thermal Recovery Time for Soft-Starter-Connected AC Motors with Intermittent Periodic Duty Cycles

Compensation For Supply And Motor Unbalances And Line Resistance For A Dc Signal Injection-Based Thermal Protection Method

A Non-Intrusive Winding Heating Method for Induction Motor Using Soft-Starter for Preventing Moisture Condensation

Impaired-Cooling-Condition Detection Using DC-Signal Injection for Soft-Starter-Connected Induction Motors

A nonintrusive thermal monitoring method for closed-loop drive-fed induction machines

Magnetic Effects of DC Signal Injection on Induction Motors for Thermal Evaluation of Stator Windings.

A NEW METHOD FOR STATOR TEMPERATURE MONITORING FOR INDUCTION MOTOR

A general approach to sensorless estimation rotor and stator windings temperature in induction motor drives

Quasi-Online Technique for Health Monitoring of Stator Winding Insulation in Inverter-Fed Motor Using Switching Transient Voltage Response

Assessment of Available Methods for Estimating Rotor Temperatures of Induction Motor

Rotor Thermal Monitoring Scheme for Direct-Torque-Controlled Interior Permanent Magnet Synchronous Machines via High-Frequency Rotating Flux or Torque Injection

Heat transfer study on a stator-permanent magnet electric motor: A hybrid estimation model for real-time temperature monitoring and predictive maintenance

Rotor Temperature Estimation Strategy for Induction Motors Based on Thermal Conductance Correction