Abstract:Moisture condensation may cause degradation of key motor components when a motor is de-energized. To prevent moisture condensation, a motor's temperature must be maintained higher than the ambient temperature when de-energized. This paper proposes a non-intrusive motor heating technique using soft-starters. By controlling the operation of the solid-state switches in soft-starters, adjustable ac current can be injected into the three phases of the stator windings without inducing any output torque. The motor temperature can therefore be maintained at a desired temperature due to the heat dissipation during current injection. In addition, two motor temperature control approaches are proposed in this paper to minimize the required energy consumption for preventing moisture condensation. The proposed technique is experimentally validated on a 7.5-hp ODP (open drip proof) induction motor. The experimental results show that the average stator winding temperature can reaches 9° above the ambient temperature with acceptable current magnitudes. In addition, it is shown that the motor temperature rise can be controlled by adjusting the operation of the solid-state switches in soft-starters. The importance of the proposed technique lies in its non-invasive nature: the technique only uses the existing hardware of soft-starters; the motor's condition is not interrupted since no output torque is induced during the current injection. The proposed winding heating technique can be easily extended to other types of ac machines or inverter-fed applications.

Magnetic Effects of DC Signal Injection on Induction Motors for Thermal Evaluation of Stator Windings.

An analysis of magnetic saturation in induction motors during dc signal injection

A DC Signal Injection-Based Thermal Protection Scheme for Soft-Starter-Connected Induction Motors

An Active Stator Temperature Estimation Technique for Thermal Protection of Inverter-Fed Induction Motors with Considerations of Impaired Cooling Detection

Sensorless Control Strategy for Multiphase Induction Motor with Stator and Rotor Resistance Identification Based on Injecting Third Harmonic Current

FEM Analysis and Application of Saturation Effect PMLSM Winding Inductance

Compensation For Supply And Motor Unbalances And Line Resistance For A Dc Signal Injection-Based Thermal Protection Method

Thermal Analysis of a Permanent Magnet Generator with Built-in Hydrostatic Drive

A Nonintrusive Thermal Monitoring Method for Induction Motors Fed by Closed-Loop Inverter Drives

A Remote and Sensorless Thermal Protection Scheme for Soft-Starter-Connected Induction Motors

A nonintrusive thermal monitoring method for closed-loop drive-fed induction machines

Impaired-Cooling-Condition Detection Using DC-Signal Injection for Soft-Starter-Connected Induction Motors

A Remote and Sensorless Stator Winding Resistance Estimation Method for Thermal Protection of Soft-Starter-Connected Induction Machines

Electromagnetic and Thermal Coupling Analysis of a Water-Cooled Double-Sided Permanent Magnet Linear Synchronous Motor

Dynamic Modeling of Surface-Mounted Permanent Magnet Motors Considering Saturation

Rotor Thermal Monitoring Scheme for Direct-Torque-Controlled Interior Permanent Magnet Synchronous Machines via High-Frequency Rotating Flux or Torque Injection

Research of Sensorless Control for Multiphase Induction Motor Based on High Frequency Injection Signal Technique

Sensorless Control for Five-phase Induction Motors With Improved Third-harmonic Current Injection

A Nonintrusive Induction Motor Stator Resistance Estimation Method Using A Soft-Starter

A Non-Intrusive Winding Heating Method for Induction Motor Using Soft-Starter for Preventing Moisture Condensation

Lumped Parameter Thermal Circuit Method Combined with Temperature Field and Flow Field Analyses for Temperature Predictions of Permanent Magnets in Motors