Abstract:Since its first introduction in the 1950s, Ti6Al4V became the most sympathetic titanium alloy due to its attractive mechanical and physicochemical properties and is currently extensively used, for e.g., in machining, automotive, aerospace, as well as biomedical industry. However, its poor tribological properties limit its use in machining, automotive, aerospace, and orthopedic applications. Hence, a variety of attempts have been made in order to improve tribological performance of titanium alloys, especially focusing on surface modification. This paper represents an overview of significance of surface modification applied on Ti6Al4V alloy. Several solutions have been followed to improve the machinability of these alloys: development of new machining techniques, tool geometries, and protection of tools' surface with coatings to yield high productivity, good surface finish of the work-piece, and extended tool life. In this work, Ni coating on Ti-based alloys is tested to evaluate their potential for machining as well as for biomedical applications. The tribological behavior is evaluated at room temperature in wet lubricated conditions on pin-on-disk equipment, by testing Ni-coated pins of 10 mm diameter and 30 mm long against EN-31 flat plate. Friction coefficient of coated pins in wet condition is observed to be less, as compared to the tests performed with uncoated pins. Coated sample tested in lubricated condition showed much more reduction in wear and friction coefficient than their performance under uncoated condition. From experimental investigation, it is observed that the Ti alloys with Ni coating show improved wear rate and friction coefficient as compared to without coating.

Surface Characterization and Mechanical Property of Tin/Ti-Coated Niti Alloy by Piiid

Surface Characterization and Electrochemical Studies of Biomedical Niti Alloy Coated with Tin by Piiid

Characterization of TiN, TiC and TiCN coatings on Ti–50.6 at.% Ni alloy deposited by PIII and deposition technique

Formation of TiN films on biomedical NiTi shape memory alloy by PIIID

Modification of Biomedical NiTi Shape Memory Alloy by TiC/Ti Films Using PIIID

Effect of N2 / Ar Gas Flow Ratio on the Deposition of TiN/Ti Coatings on NiTi Shape Memory Alloy by PIIID

Surface characterization and immersion tests of TiNi alloy coated with Ta

Study of optical and electrical properties of TiN thin films prepared by cathodic ion sputtering

Nanoindentation and Tribological Behavior of TiN-TiCN-TiAlN Multilayer Coatings on AISI D3 Tool Steel

Tantalum Coated NiTi Alloy by PIIID for Biomedical Application

A Study Of Zrn/Zr Coatings Deposited On Niti Alloy By Piiid Technique

Fabrication and Performance of TiN/TiAlN Nanometer Modulated Coatings

Ti/TiN multilayer coatings: deposition technique, characterization and mechanical properties

Performance Assessment of Ni-Coated Titanium Alloys Under Wet Conditions

Characterisation of TiCN Coatings for Biomedical Applications

Tribological properties of Ti-N compound layer formed on Ti6Al4V by HCD assisted plasma nitriding

Surface characteristics and electrochemical corrosion behavior of NiTi alloy coated with IrO2

Surface Performance of Nano-CrN/TiN Multi-Layered Coating on the Surface of Ti Alloy

Microstructure and Mechanical Properties of Co-Deposited Ti-Ni Films Prepared by Magnetron Sputtering

The Effects of Surface Roughness on the Durability of Polydopamine/PTFE Solid Lubricant Coatings on NiTiNOL 60

(AlCrNbSiTi)N/TiN multilayer films designed by a hybrid coating system combining high-power impulse magnetron sputtering and cathode arc deposition