Abstract:Water splitting with solid oxide electrolysis cells (SOECs) has gained increasing attention as an efficient, affordable, and sustainable technology for hydrogen production. Since electricity represents the bulk of projected hydrogen cost for operating SOECs, enhancing the utilization efficiency of electricity (electrochemical energy efficiency) is critical to reach the cost-effective milestone for cell/electrolyzer development. In this study, we present a SOEC design with an ultra-thin solid electrolyte (based on an yttria-stabilized zirconia material) layer as well as an electrode support layer with reduced thickness to minimize the cell resistance. The thin electrolyte and electrode-support layers were fabricated with our optimized tape casting process. In addition to reducing the cell resistance, the implementation of thin electrolyte and electrode-support layers offers a facile and short path for gas diffusion, which can reduce the efficiency loss caused by diffusion. With our optimized cell configuration design, a high electrolysis current density was achieved at 750 o C. Over the process of cell-configuration optimization, electrochemical impedance spectroscopy (EIS) and microscopic analysis were systematically performed on the cell and cell components to rationalize the cell architecture toward accessing high electrochemical performance and high energy efficiency of the SOEC. The relevant analysis strategies and results will be presented as well.

Preparation and Electrochemical Performance of Hydrogen Electrode and Electrolyte for SOEC by Tape Casting and Lamination

A simple and easy one-step fabrication of thin BaZr0.1Ce0.7Y0.2O3−δ electrolyte membrane for solid oxide fuel cells

Preparation And Co-Sintering Of Electrolyte And Hydrogen Electrode Via Tape Casting And Its Performances For Soec

Study on Co-Sintering of Hydrogen Electrode and Electrolyte Prepared by Tape Casting for Solid Oxide Electrolysis Cell

Fabrication of anode supported solid oxide electrolysis cell with the co-tape casting technique and study on co-electrolysis characteristics

Electrochemical Property of Multi-Layer Anode Supported Solid Oxide Fuel Cell Fabricated Through Sequential Tape-Casting and Co-Firing

Preparation and Electrochemical Behavior of Dense Ysz Film for Soec

High performance solid oxide electrolysis cell with impregnated electrodes

Preparation and Characterization of NiO/YSZ Cathode and BSCF/SDC Anode of SOEC for Hydrogen Production

Fabrication of Electrode Supporters for Solid Oxide Fuel Cells by Tape Calendaring Process

Effect of Composite Pore Former on the Electrochemical Performance of Hydrogen Electrode in SOEC

A Solid Oxide Electrolysis Cell (SOEC) with High Current Density and Energy Efficiency for Hydrogen Production

Co-sintering anode and Y 2O 3 stabilized ZrO 2 thin electrolyte film for solid oxide fuel cell fabricated by co-tape casting

Preparation Of Nanosized Nio-Ysz Composite Powders By Situ-Precipitation Method

Preparation of NiO–YSZ composite powder by a combustion method and its application for cathode of SOEC

Fabrication and Characterization of a Cathode-Support Solid Oxide Fuel Cell by Tape Casting and Lamination

Preparation and Performance of IT-SOFC with Anode-Supported Thin GDC Electrolytes by Tape Casting Process

Reversible fuel electrode supported solid oxide cells fabricated by aqueous multilayered tape casting

Increased Porosity in NiO-YSZ Tubular Substrate for High Performance Solid Oxide Electrolysis Cell Using LaGaO3 Film

Microstructure and electrochemical characterization of solid oxide fuel cells fabricated by co-tape casting

Steam Electrolysis in a Solid Oxide Electrolysis Cell Fabricated by the Phase-Inversion Tape Casting Method