Abstract:The tribological performance of copper-based powder metallurgical material is much influenced by the interfacial bonding between the components and matrix. By adding Cu-coated or uncoated graphite particles as a lubricant, two types of copper-based powder metallurgical materials were prepared via spark plasma sintering (SPS). The hardness, relative density, and thermal conductivity of the two specimens were firstly measured. Using an inertial braking test bench and temperature measuring instrument, the average friction coefficients, instantaneous friction coefficients, and friction temperatures of the two specimens were tested under different test conditions, and the wear rates were calculated accordingly. Based on the analysis of surface morphologies and elements distribution after the tests, the mechanisms of wear and formation of friction films were discussed. The results show that with the lubricant of Cu-coated graphite, the hardness, relative density, thermal conductivity, and interfacial bonding between the graphite and matrix can be greatly improved. Under the same test condition, the average friction coefficient, wear rate, and friction temperature of the specimen with added Cu-coated graphite are both lower than those of the specimen with added uncoated graphite. The two specimens show different variation trends in the instantaneous friction coefficient during the tests, and the variation of the instantaneous friction coefficient at a high initial test speed is also different from that at a low initial test speed for each specimen. The two specimens also show differences in the continuity of friction film and the content of graphite and oxide in the friction film.

Study on the Tribological Performance of Tin Bronze-Steel Bimetal Solid Self-lubricating Composites

A Comparative Investigation of the Tribological Behavior and Wear Mechanism of Bronze-graphite Composite under Dry- and Water-lubricated Sliding Against Steel

Study on the Tribological Characteristics of Solid Lubricants Embedded Tin‐bronze Bearings

Study on Tribological Behavior of Bronze Matrix Self-lubricating Composites

Tribological characteristics of solid-lubricant embedded Tin-bronze bearings

Microstructure, Microhardness and Tribological Properties of Bronze-Steel Bimetallic Composite Produced by Vacuum Diffusion Welding

Effects of Graphite Contents on the Microstructure Evolution, Mechanical Properties and High Temperature Tribological Behavior of Cu–Ni–Al/Gr Solid-Lubricating Composites

Preparation and Wear Performance of Novel Graphite/Copper Alloy-Matrix Self-Lubricating Composite Materials

On the tribological behaviors of Cu matrix composites with different Cu-coated graphite content

Tribological Behavior and Lubrication Mechanism of Self-Lubricating Ceramic/Metal Composites: the Effect of Matrix Type on the Friction and Wear Properties

Study on the lubrication film formation and characteristics of different graphite seal composites

Study on the tribological properties of MoB/Cu laminated composite materials fabricated by hot-pressing process

Effect of Ti3SiC2 replacing graphite on the microstructure and properties of Cu-Sn matrix composites

Self-lubrication Behavior of the Reaction-Formed Graphite/sic Composites with Optimizing Graphite Content

STUDY ON ABRASION MECHANISM OF SHORT CARBON FIBER REINFORCED Cu ALLOY MATRIX COMPOSITES

Study on the Tribological Performance of Copper-Based Powder Metallurgical Friction Materials with Cu-Coated or Uncoated Graphite Particles as Lubricants

Study on friction and wear behaviors of ceramic-graphite composite

Effect of the Ni coated graphite powders addition on the properties of the Fe-based solid self-lubricating composites

Study on Friction and Wear Properties of New Self-Lubricating Bearing Materials

Preparation and tribological behaviours of graphite self-lubricating coating deposited on middle carbon steel by electrospark deposition

Research on Synergistic Lubrication Effect of Silver Modified Cu–Ni-graphite Composite