Abstract:Assorted morphologies of precipitates in fcc/bcc transformation systems have been reported, which often exhibit irrational characteristic. Various models have been developed to explain the habit plane (or the broad facet), but the overall morphologies of the precipitates are seldom explained quantitatively. In this work, the equilibrium cross-section of rod-shape austenite precipitates in duplex stainless steel is determined by atomistic simulation. The input orientation relationship (OR) between fcc and bcc phase is determined according to the O-line criterion (one of the interfaces contains a single set of dislocations), with the condition that the invariant line lies in close-packed plane pair of (1 (1) over bar(1) over bar)(f)|(10 (1) over bar)(b) and the Burgers vector of O-lines is [011](f|)/2|((1) over bar 11)(b)/2. The obtained OR is close to the K-S OR ((11 (1) over bar)(f)//(01 (1) over bar)(b), [101](f)//(111)(b)), with the deviation of 1.27 degrees from the parallelism in both planes and directions. Interfacial energy of interfaces in various orientations in the zone axis of the invariant line ([0.75 0.10 0.65](f)//[0.52 0.68 0.52](b)) has been calculated. To ensure the reliability of the calculated values, an initial atomic configuration free of interstitial and vacancy is constructed for each interface. The energies of the O-line interface, the interface normal to either Delta g(((1) over bar 11)) or Delta g((020)) are found to have similar values, each at a local minimum. Based on the calculated interfacial energies, the equilibrium cross-section morphology is determined by the Wulff construction. The result shows that the morphology exhibits a near rhombus cross-section, which agrees consistently with experiments. One of the major facets is the O-line interface, normal to ((0.66) over bar 0.12 0.74)(f)//((0.51) over bar (0.24) over bar 0.83)(b), in agreement with the observation. The other facet is normal to Delta g((020)) (((0.25) over bar (0.87) over bar 0.42)(f)//(0.45 (0.73) over bar 0.51)(b)) in the calculated result, while it is normal to Delta g(((1) over bar 11)) (((0.36) over bar (0.77) over bar 0.53)(f)//(0.31 (0.71) over bar 0.63)(b)) in experimental results, with about 10 degrees difference between them. The discrepancy between calculated and observed results is probably because the experiments have not reached the equilibrium state. The dislocation structures in these three interfaces are identified from the atomic simulation results by a newly developed method based on the singular value decomposition of the Nye tensor. It confirms that the O-line interface contains a single set of [011](f)/2 dislocations with spacing of 1.5 nm. The interface normal to either Delta g(((1) over bar 11)) or Delta g((020)) contains two sets of dislocations. The dislocation structure in the facet normal to Delta g((1) over bar 11)) is in good agreement with experimental observation of the non-O-line facet, including the local decomposition of dislocation core to (1 (1) over bar(1) over bar)(f) stacking faults.

The Invariant Line and Precipitate Morphology in Fcc-Bcc Systems

An Extended Invariant Line Analysis for Fcc/bcc Precipitation Systems

A Systematic Study of Irrational Precipitation Crystallography in Fcc–bcc Systems with an Analytical O-line Method

Minimum Interface Misfit Criterion for the Precipitation Morphologies of TCP Phases in a Ni-based Single Crystal Superalloy

An Investigation on the Equilibrium Morphology and Interfacial Structures of Pricipitates in Duplex Stainless Steel by Atomistic Simulation

A two-dimensional analytical approach for phase transformations involving an invariant line strain

From coherent to semicoherent-Evolution of precipitation crystallography in an fcc/bcc system

The BCC-FCC Phase Transformation Pathways and Crystal Orientation Relationships in Dual Phase Materials From Al-(Co)-Cr-Fe-Ni Alloys

From coherent to semicoherent Evolution of precipitation crystallography in an fcc/bcc system

From Coherent to Semi-Coherent — Evolution of Precipitation Crystallography in an fcc/bcc System

A systematic study on the interfacial energy of O-line interfaces in fcc/bcc systems

Analytical O-line Solutions to Phase Transformation Crystallography in Fcc/bcc Systems

A Simple Method for Calculating the Possible Habit Planes Containing One Set of Dislocations and Its Applications to Fcc/bct and Hcp/bcc Systems

A TEM Study of the Crystallography of Austenite Precipitates in a Duplex Stainless Steel

Structures and energetics of semicoherent interfaces of precipitates in hcp/bcc systems: A molecular dynamics study

An Extended Near-Coincidence-sites Method and the Interfacial Structure of Austenite Precipitates in a Duplex Stainless Steel

Near-coincidence-sites modeling of the edge facet dislocation structures of α precipitates in a Ti–7.26 wt.% Cr alloy

Effects of precipitate size and spacing on deformation-induced fcc to bcc phase transformation

A General Crystallographic Model of Fcc/Bcc(Bct) Martensitic Nucleation and Growth in Steels

Diffuse-interface Approach to Predicting Morphologies of Critical Nucleus and Equilibrium Structure for Cubic to Tetragonal Transformations

O-lattice Analyses of Interfacial Misfit. II. Systems Containing Invariant Lines