Abstract:Densified ZrB2–SiC-based ultra-high temperature ceramics reinforced with short carbon fibers were prepared by conventional hot-pressing. The microstructure, mechanical and oxidation resistance properties of the composite were investigated. The Csf/ZrB2–SiC composite had improved fracture toughness of 6.6MPam1/2 compared to ZrB2–SiC composite of 4.3MPam1/2 due to fiber debonding, fiber pull-out and fiber bridging as well as crack deflection. It was found that the low modulus of carbon fiber and a graphitization transition layer between fiber and matrix led to the decreased flexural strength. The oxidation resistance tests were carried out on Csf/ZrB2–SiC using an oxyacetylene torch. The temperature of the oxidized specimen exceeded 1800°C and the surface layer appeared dense and adherent. No macro-cracks or spallation were detected, suggesting that these composites possess a better oxidation resistance than ZrB2–SiC. The improved oxidation resistance is attributed to the formation of a coherent SiO2 rich scale, which acts as an effective barrier against the inward diffusion of oxygen. The results presented here point to a potential way for improving toughness of composite without sacrificing oxidation protection.

THE RESEARCH SITUATION OF THE THE HIGH-TEMPERATURE RESISTANCE OF Si3N4 BONDED SiC COMPOSITES

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

High-temperature tensile behavior of 3D SiC/SiC composites

High-Temperature Properties of SiC-Si3N4 Particle Composites

Enhanced thermal shock resistance of BN-based composites sintered by hot-pressing with the introduction of nano oxides

Heat-resistant Joints of Si3N4 Ceramics with Intermetallic Compounds Formed in Situ

Thermal Shock and Residual Strength Testing of SiC/SiC Composite Braided Tubes

Molecular dynamics simulation of the temperature effect on ideal mechanical properties of SiC/BN interface for SiCf/SiC composites

Solid-liquid state bonding of Si3N4 ceramics and its joint high-temperature properties

High temperature bending properties and failure mechanism of 3D needled C/SiC composites up to 2000 °C

Microstructure, mechanical properties and thermal shock behavior of h-BN-SiC ceramic composites prepared by spark plasma sintering

Temperature‐dependent mechanical and oxidation behavior of in‐situ formed ZrN/ZrO2‐containing Si3N4‐based composite

Preparation and flame ablation/oxidation behavior of ZrB2/SiC ultra-high temperature ceramic composites

Thermal Shock Resistance of in Situ Formed Si2N2O–Si3N4 Composites by Gelcasting

Characterization of hot-pressed short carbon fiber reinforced ZrB2–SiC ultra-high temperature ceramic composites

Mechanical Properties of Si3N4/BN Fibrous Monolithic Ceramics at Elevated-Temperature

Effect of temperature on the structure and mechanical properties of SiC–TiB2 composite ceramics by solid-phase spark plasma sintering

Oxidation Behavior of SiC/SiC Composites in Air at High Temperature

Influence of the heat treatment on mechanical properties and oxidation resistance of SiC–Si3N4 composites

Effect of SiC on the anti-ablation resistance and flexural strength of (Hf-Ta-Zr)C-C/C composites