Analysis of Longitudinal Cracking and Mold Flux Optimization in High-Speed Continuous Casting of Hyper-Peritectic Steel Thin Slabs
Zhipeng Yuan,Liguang Zhu,Xingjuan Wang,Kaixuan Zhang
DOI: https://doi.org/10.3390/met14080909
IF: 2.695
2024-08-12
Metals
Abstract:Longitudinal crack defects are a frequent occurrence on the surface of thin slabs during the high-speed continuous casting process. Therefore, this study undertakes a detailed analysis of the solidification characteristics of hyper-peritectic steel thin slabs. By establishing a three-dimensional heat transfer numerical model of the thin slab, the formation mechanism of longitudinal cracks caused by uneven growth of the initial shell is determined. Based on the mechanism of longitudinal crack formation, by adjusting the performance parameters of the mold flux, the contradiction between the heat transfer control and lubrication improvement of the mold flux is fully coordinated, further reducing the incidence of longitudinal cracks on the surface of the casting thin slab. The results show that, using the optimized mold flux, the basicity increases from 1.60 to 1.68, the F- mass fraction increases from 10.67% to 11.22%, the Na2O mass fraction increases from 4.35% to 5.28%, the Li2O mass fraction increases from 0.68% to 0.75%, and the carbon mass fraction reduces from 10.86% to 10.47%. The crystallization performance and rheological properties of the mold flux significantly improve, reducing the heat transfer performance while ensuring the lubrication ability of the molten slag. After optimizing the mold flux, a surface detection system was used to statistically analyze the longitudinal cracks on the surface of the casting thin slab. The proportion of longitudinal cracks (crack length/steel coil length, where each coil produced is about 32 m long) on the surface of the thin slab decreases from 0.056% to 0.031%, and the surface quality of the thin slab significantly improves.
materials science, multidisciplinary,metallurgy & metallurgical engineering