Abstract:This work investigates the heterogeneous deformation and failure of HR3C austenitic stainless steel welded joints at room and typical service temperatures. Such types of welded joints are widely used in the new generation of fossil fuel power stations and are known to suffer from premature high temperature failure. Observation of in-service failures revealed that cracks may nucleate either in the heat affected zone or in the weld metal. The main objective of this work is to identify the local microstructural conditions and stress–strain fields responsible for both ductile failure and micro-crack nucleation within the weldment at low and high temperatures, respectively. To that purpose, a novel multi-scale micromechanics-based modelling framework is proposed. It relies on representative weld microstructure models digitally reconstructed from EBSD measurements, and dislocation density-based crystal plasticity models to describe the behaviour of individual grains in each weld region. A novel thermo-dynamically consistent relation for the configuration stored energy per unit volume is derived from the crystal plasticity framework. The single crystal models are calibrated and validated from a combination of uniaxial tensile tests on cross-weld specimens using high resolution digital image correlation techniques, representative volume elements of the polycrystals at the macro-scale, as well as micropillar compression tests at the scale of the individual grains. Predictions of heterogeneous inelastic deformation fields within the weldment at both 22 °C and 665 °C, and of micropillar compression behaviour of the individual weld single crystal phases are consistent with experimental data. The experimentally observed ductile failure of the weld metal at room temperature is successfully predicted using a Gurson-type void nucleation, growth and coalescence constitutive model. The suitability of the stored strain energy density and the accumulated plastic strain as crack initiation/creep failure indicators is investigated. It was found that predicted creep lifetimes with either indicator were very similar, and that they were relatively accurate for low stress levels.

Cause Analysis and Preventive Measures against Cracks in 15Cr1Mo1V Steel Welded Joint in Service

Cause Analyses of the Weld Seam Cracks of a Prehydrogenating Reactor

Investigation on Crack Propagation Failure Modes of Short Carbon Fiber Reinforced Polyethylene Electrofusion Joints

Cause Analysis and Improvement Measures for Pipeline Cracking of 9Cr-1Mo Material

Ageing Embrittlement of 15Cr1Mo1V Steel Welded Joints Evaluated by Small Punch Test

Effect of Welding Defects on Mechanical Properties of Welded Joints Subjected to Temperature

The Causes and Control of Longitudinal Edge Cracks of the Plate

Micro-mechanics investigation of heterogeneous deformation fields and crack initiation driven by the local stored energy density in austenitic stainless steel welded joints

Study on Type IV Cracking Behavior of T92/Super304H Dissimilar Steel Welded Joints in Long-Term Service

Near-threshold Fatigue Crack Growth Behavior of the Weld Metal and Heat-Affected Zone in an Ex-Service CrMoV Steel Joint

Insights into microstructure evolution and fracture mechanisms of welded joints of high strength steel patchwork components

Review of Reheat Crack in Welded Joint of Low Alloy Heat-Resistant Steels

Analysis of Crack Propagation of Annular Butt Weld and Distribution of Weld-Induced Residual Stress

Types and Cause of Cold Bending Crack Defects of Welded Pipe

Analysis of weld root fatigue cracking in load-carrying high-strength aluminum alloy cruciform joints

Analysis of crack causes and effects of the A333 low carbon pipeline steel after thermite welding

Studies on Mechanism of Zigzag Crack Forming Process in Weld Metal of Narrow Gap Submerged Arc Welding of Thick Plate

Microstructural effects on central crack formation in hot cross-wedge-rolled high-strength steel parts

[The problem of selection of newborn infants with myelomeningocele for surgery. The effect of the surviving infants on the rest of their family].

Cracking Analysis on X80 Steel Oil Pipe during JCOE Forming

Analysis for a crack of the manhole in a reactor of Ethidene Diamine unit