Abstract:Numerical simulation was performed on the combustion and contamination generation process under the original scheme and four retrofit schemes with different positions of coal reburning injector using conventional pulverized coal as reburning fuel with the rated load in a 410 t/h tangentially fired furnace in a domestic thermal power plant with CFD software platform. Results show that thermal NOx can be restrained since the highest temperature decreases when the volume heat load qv of burner zone decreases due to extending the burner zone in the reburning retrofit. The better NOx reduction can be achieved since the lower NOx concentration from the main combustion zone where the low oxygen combustion can restrain the NOx. The lower position of reburning injector, the less NOx reduction can be achieved due to the disturbance effect from main combustion zone. On the other hand, the higher position of reburning injector, the less NOx reduction, the higher temperature of the outlet of furnace and the higher unburned carbon of fly ash can also be achieved due to the shorter settle time of reburning coal, but the better NOx reduction can be achieved through choosing an appropriate position of reburning injector. The NOx reduction of 47.66% can be achieved by using low oxygen primary combustion zone, appropriate position of reburning injector, and OFA. Further more, all parameters of the boiler run well and thermal efficiency of the boiler is increased slightly. Therefore, the satisfied NOx reduction can be achieved using conventional pulverized coal as reburning fuel for the low ash content and flammable bituminous coals. Engineering testing shows that the results from numerical simulation are in conformity with real operation condition.

Feasibility Study on the Reburning with Fine Coal Particles Based on Tertiary Air Retrofit in Pulverized Coal Fired Boilers

The Application of Rotary-Classifier in the Reburning System

Experimental Study and Numerical Simulation of Rotary-classifier

Experimental Study on Micronized Coal Reburning for a 200MW Coal-fired Boiler

STUDY ON ELIMINATING FIRE-CARRYING IN PRIMARY AIR JET ORIFICE BY ADMIXING EXHAUST GAS

Experimental Study and Numerical Simulation on Tertiary Air Reburning with Different Micronized Coal Content

Numerical Simulation of Pulverized-coal Reburning Technology for a Large-sized Lignite-fired Boiler

STUDY ON IMPROVEMENT OF BURNING BEHAVIOR FOR INDONESIAN COAL AND ITS APPLICATION ON 300 MW UNITS

STUDY OF COAL RANK AND FINENESS ON NOx REDUCTION WITH COAL REBURNING TECHNOLOGY

An Experimental Study on Controlling CO and N2O Emission of Boiler Through Pulverized Coal Reburn

Combustion System Renovation of 125MW Unit for Enhancing Coal Suitability and the Influence on NOx Emission

Analyzing Factors of Unburned Coal in Fly Ash During Pulverized Coal Reburning

Experimental Research on NOx Reduction in Furnace with Coal Reburning

Parametric study of reburning of nitrogen oxide for superfine pulverized coal

Experimental Research on Fine Pulverized-coal

STUDY ON NUMERICAL SIMULATION OF DECREASING NOx EMISSION THROUGH RETROFITTING CORNER TANGENTIAL FIRING PULVERIIED COAL BOILER WITH SOFA

Experimental Study on Coal Reburning Dynamic Process for NOx Reduction

Study and Actualization of Burning Bituminous Coal in Lean Coal-fired Boiler of the 300 MW Unit

Tertiary air operation optimization aiming at low NOx combustion in boiler

TEST AND STUDY ON NOx REDUCTION WITH MICRONIZED COAL-DUST REBURNING

Selection of Position of Pulverized Coal Reburning Injector in Low NO_x Retrofit Schemes