Effect of Constraint Induced by Crack Depth on Creep Crack-Tip Stress Field in CT Specimens

Guozhen Wang,Xiaoli Liu,Fu-Zhen Xuan,Shan-Tung Tu

DOI: https://doi.org/10.1016/j.ijsolstr.2009.09.015

IF: 3.667

2009-01-01

International Journal of Solids and Structures

Abstract:In this paper, the effect of constraint induced by the crack depth on creep crack-tip stress field in compact tension (CT) specimens is examined by finite element analysis, and the effect of creep deformation and damage on the Hutchinson–Rice–Rosengren (HRR) singularity stress field are discussed. The results show the constraint induced by crack depth causes the difference in crack-tip opening stress distributions between the specimens with different crack depth at the same C*. The maximum opening stress appears at a distance from crack tips, and the stress singularity near the crack tips does not exist due to the crack-tip blunting caused by the large creep deformation in the vicinity of the crack tips. The actual stress calculated by the finite element method (FEM) in front of crack tip is significantly lower than that predicted by the HRR field. Based on the reference stress field in the deep crack CT specimen with high constraint, a new constraint parameter R is defined and the constraint effect in the shallow crack specimen is examined at different distances ahead of the crack tip from transient to steady-state creep conditions. During the early stages of creep constraint increases with time, and then approaches a steady state value as time increases. With increasing the distance from crack tips and applied load, the negative R increases and the constraint decreases.