Abstract:The preparation of precursor sol is the first and crucial step in fabricating oxide fibers by the sol–gel method. In this study, different aluminum-silica sols were prepared by adjusting the alumina and silica source mixing procedure using aluminum carboxylate sol and tetraethoxysilane (TEOS) as the aluminum source and silicon source, respectively. Continuous alumina-mullite precursor fibers were obtained by dry spinning and the effects of alumina and silica source mixing procedure on the phase transition and microstructure evolution of alumina-mullite composite fibers were investigated. The results showed that the mullite formation temperature in the fibers obtained by adding TEOS during the preparation of aluminum carboxylate sol was about 1300 °C, while it was 800 °C in the fibers obtained by mixing aluminum carboxylate sol and TEOS. In addition, the grain size of the fibers obtained by adding TEOS during the preparation of aluminum carboxylate sol was significantly smaller than that obtained by mixing aluminum carboxylate sol and TEOS. The mechanism of this difference was that the aluminum-silica sol obtained by adding TEOS during the preparation of aluminum carboxylate sol was a diphasic sol, while the aluminum-silica sol obtained by adding TEOS in the prepared aluminum carboxylate sol was a monophasic sol.Graphical Abstract

Synthesis on microcosmic structural characterization of precursors gels of the continuous Al2O3-SiO2 fiber

Synthesis and characterization of sol-gel derived continuous spinning alumina based fibers with silica nano-powders

Preparation and Characteristics of Spinnable Sol and Continuous Mullite Fibers with Nano Silica Addition

Effect of the alumina and silica source mixing procedure on the microstructural evolution of alumina-mullite composite fibers prepared by sol–gel method

Preparation of Mullite Fibers by Sol-Gel Process and Study of Their Morphology

Preparation and Crystallization of Si-Al Gel

Preparation of Continuous Alumina Fiber with Nano Grains by the Addition of Iron Sol

Synthesis and Characterization of Electrospun Mullite Nanofibers

Preparation and Application of Spinnable Zirconium Sol I.Preparation of Continuous Zirconia Fiber

Mullite Fibers Prepared by Sol-Gel Method Using Aluminum Chloride Aluminum Isopropoxide and Tetraethylorthosilicate

Research Development for the Fabrication of Inorganic Continuous Mullite Fiber

Polycrystalline Nanograin Formation in Uniform-Sized Silicon Carbide Fibers Derived from Aluminum-Containing Polycarbosilane

The characteristics of spinnable mullite sol prepared by sol-gel method

Mullite Fibers Prepared from an Inorganic Sol–gel Precursor

Study On Preparation Of Sio2 Optical Fiber Preform By Sg Method

Microstructures of Nanosized Alumina Powders Synthesized by Sol-Gel Method

Structural Characterization of Mesoporous Silica Nanofibers Synthesized Within Porous Alumina Membranes

Effects of SiO2 Addition on Phase Transition and Microstructure Evolution of Alumina Fibers Prepared Using the Sol-Gel Method

Synthesis and Characterization of Rich Silica Mullite Fibers by Sol–Gel Method Using Aluminum Lactate and Silica Sol

The Synthesis and Characterization of SiO_2-Al_2O_3 Xerogels

Synthesis and structural characterization of SiO2-Al 2O3 xerogels