Abstract:When the grain size is below a critical value, the deformation mechanism of nanocrystalline (NC) metal shifts from dislocation- to grain boundaries (GBs)-mediated activities. However, GB activities including deformation and rotation in the elastic and plastic stages have not given detailed analysis because of the limitation of current experimental techniques, as well as the unrealistic model with regular boundaries in most molecular dynamics (MD) simulation reducing the activities. To quantitatively analyze GB activities, we recently developed an algorithm based on moving least-squares interpolant. Besides, the phase field model was used to build the nanocrystalline (NC) Cu with more natural GBs for MD tensile simulation. The results of temperature dependence of Young's modulus (E), strain rate sensitivity (SRS), and variation of stress at GBs (σGB) and at grain interiors (σGI) are in good agreement with previous researches. In the elastic stage, the σGB fluctuates in a larger range than σGI. The vibrated σGB is the results of micro-elastic and micro-plastic deformation of GBs and the increased stage of σGB in one cycle can lead to increasing the σGI. Thus, the temperature dependence of E is affected by the frequency of vibrated σGB at relative low temperatures (T ≤ 450 K). The E is strain rate independent because of the same vibration of σGB. In the plastic stage, the flow stress strongly depends on the size of twinning boundaries (TBs) structures. The fraction of GB activities improves with increasing temperature and decreasing strain rate. GB activities can attenuate stress concentration on boundaries and then results in the formation and growth mechanism of TB changing from Shockley partial dislocation gliding on adjacent plane of stacking faults (SFs) to GB deformation. Thus, the size of TB at low temperatures and high strain rate is larger than that at the opposite conditions.

Deformation Behaviour of Ultra-Fine-grained Copper

Effect of cryogenic impact deformation and subsequent annealing on microstructure and microhardness of pure copper

Strain Softening Mechanism at Meso Scale During Micro-Compression in an Ultrafine-Grained Pure Copper

An investigation of slip transmission during uniaxial tensile deformation of a coarse-grained copper via EBSD characterization and crystal plasticity modelling

The Meso-inhomogeneous Deformation of Pure Copper under Tension–Compression Cyclic Strain Loading

Microstructural Changes Produced by Fatigue in High-Purity Copper Severely Deformed by Cryogenic Rolling

Strain localization and ductile fracture mechanism of micro/mesoscale deformation in ultrafine-grained pure copper

Simultaneous Grain Growth and Grain Refinement in Bulk Ultrafine-Grained Copper under Tensile Deformation at Room Temperature

Mechanisms Of Cyclic Plastic Deformation In Ultrafine-Grain Copper Produced By Severe Plastic Deformation

Compressive Behavior and Rate-Controlling Mechanisms of Ultrafine Grained Copper over Wide Temperature and Strain Rate Ranges

Compressive deformation behavior of ultrafine-grained Mg-3Zn-1.2Ca-0.6Zr alloy at room temperature

Size-dependent deformation mechanisms in copper gradient nano-grained structure: A molecular dynamics simulation

Dynamic Deformation Mechanism in Submicro-Laminated Copper with Interlamellar Graphene Multilayers

Deformation Behavior and Microstructural Evolution of T-Shape Upsetting Test in Ultrafine-Grained Pure Copper

Microstructural evolution of pure copper subjected to friction sliding deformation at room temperature

Deformation Behavior and Microstructure Evolution of Graphene/copper Laminated Composites

Influence of grain boundary activites on elastic and plastic deformation of nanocrystalline Cu as studied by phase filed and atomistic simulaiton

Experimental Investigation on Strain Rate Sensitivity of Ultra-Fine Grained Copper at Elevated Temperatures

Tensile Ductility of Ultra-Fine Grained Copper at High Strain Rate

Temperature And Strain Rate Sensitivity Of Ultrafine-Grained Copper Under Uniaxial Compression

Deformation Behavior and Microstructural Evolution of Al-Zn-Cu-Mg-Sc-Zr Alloy During High Temperature Compression