Abstract:This paper presents a novel decoupled two degrees of freedom (2-DOF) translational parallel micro-positioning stage. The stage consists of a monolithic compliant mechanism driven by two piezoelectric actuators. The end-effector of the stage is connected to the base by four independent kinematic limbs. Two types of compound flexure module are serially connected to provide 2-DOF for each limb. The compound flexure modules and mirror symmetric distribution of the four limbs significantly reduce the input and output cross couplings and the parasitic motions. Based on the stiffness matrix method, static and dynamic models are constructed and optimal design is performed under certain constraints. The finite element analysis results are then given to validate the design model and a prototype of the XY stage is fabricated for performance tests. Open-loop tests show that maximum static and dynamic cross couplings between the two linear motions are below 0.5% and -45 dB, which are low enough to utilize the single-input-single-out control strategies. Finally, according to the identified dynamic model, an inversion-based feedforward controller in conjunction with a proportional-integral-derivative controller is applied to compensate for the nonlinearities and uncertainties. The experimental results show that good positioning and tracking performances are achieved, which verifies the effectiveness of the proposed mechanism and controller design. The resonant frequencies of the loaded stage at 2 kg and 5 kg are 105 Hz and 68 Hz, respectively. Therefore, the performance of the stage is reasonably good in term of a 200 N load capacity.

Investigation of the Vibration Characteristic of a Dual-drive Precision Stage

Design And Analysis Of Two Dimensional X-Y Micropositioning Stage

Optimization Analysis of Vibration Characteristics for Precision Positioning Stage

BASIC THEORY AND TECHNOLOGY IN THE ACTIVE VIBRATION ISOLATION OF PRECISION DEVICES

Comprehensive Dynamic Model and Vibration Characteristics of Step-Type Compound Planetary Gear Sets

Modeling and analyzing of an H-drive precision XY stage

Dual Drive System Modeling And Analysis For Synchronous Control Of An H-Type Gantry

Design and Cooperation Control Analysis of a Coarse-Fine Dual Stage Drive Positioning System

Vibration Control in a Dual-Drive Planar Parallel Robot

Advanced Synchronization Control of a Dual-Linear-Motor-Driven Gantry with Rotational Dynamics.

Nonlinear dynamics investigation of a multi-axis drive system due to the kinematic joints

A Novel Hybrid Actuation Mechanism Based XY Nanopositioning Stage with Totally Decoupled Kinematics

Precision Stage Motion Controller Based on a Vibration Model

The Investigation and Experimentation on Vibration Isolation System of Ultra-high Precision Stage

Investigation of electromechanical coupling vibration characteristics of an electric drive multistage gear system

Design and control of a decoupled two degree of freedom translational parallel micro-positioning stage

Dynamic Modeling and Analysis of a 3-DOF Ultra-precision Positioning Stage with Air Bearinga

Design and Testing of a Novel Two-Axial Flexure-Based Vibration Stage

Modeling and Synchronization Control of a Dual Drive Industrial Gantry Stage

Design, modeling and control of a novel parallel kinematics servo gantry for high precision tracking

Coupled Dynamic Modeling and Analysis of Ultra-precision 6-DOF Fine Stage