Abstract:Equal channel angular expansion extrusion with spherical cavity (ECAEE-SC) was introduced as a novel severe plastic deformation (SPD) technique, which is capable of imposing large plastic strain and intrinsic back-pressure on the processed billet. The plastic deformation behaviors of commercially pure aluminum during ECAEE-SC process were investigated using finite element analysis DEFORM-3D simulation software. The material flow, the load history, the distribution of effective strain and mean stress in the billet were analyzed in comparison with conventional equal channel angular extrusion (ECAE) process. In addition, single-pass ECAEE-SC was experimentally conducted on commercially pure aluminum at room temperature for validation, and the evolution of microstructure and microhardness of as-processed material was discussed. It was shown that during the process, the material is in the ideal hydrostatic stress state and the load requirement for ECAEE-SC is much more than that for ECAE. After a single-pass ECAEE-SC, an average strain of 3.51 was accumulated in the billet with homogeneous distribution. Moreover, the microstructure was significantly refined and composed of equiaxed ultrafine grains with sub-micron size. Considerable improvement in the average microhardness of aluminum was also found, which was homogenized and increased from HV 36.61 to HV 70.20, denoting 91.75% improvement compared with that of the as-cast billet.

Effect of Friction on Equal Channel Angular Extrusion Process

Influence of Friction Resistance on the Deformation of Pure Aluminum during Equal Channel Angular Extrusion Processing

Tensile and Compressive Deformation Behaviors of Commercially Pure Al Processed by Equal-Channel Angular Pressing with Different Dies

Estimation of Friction During Equal Channel Angular (ECA) Pressing of Aluminum Alloys

Tensile Deformation Behaviors of CuNi Alloy Processed by Equal Channel Angular Pressing

A New Near Equal Channel Angular Extrusion Design and Relative Finite Element Analysis

Finite Element Analysis of Influence of Friction Coefficient on Equal Channel Angular Extrusion of Titanium Alloy

Computer Simulation of the Effects of Friction on the Formation of Equal Channel Angular Pressing

Finite Element Analysis for the Influence of Curvature Angle ψ of the Outside Corner on ECAE of Pure Aluminum

Friction Properties of TiNi Alloy Fabricated by Equal Channel Angular Extrusion

Influence of Inner Fillet Radius on Effective Strain Homogeneity in Equal Channel Angular Pressing

Numerical Simulation of Semi-Solid Billet Preparation by Equal Channel Angular Extrusion

Influence of Equal Channel Angular Extrusion on the Properties of Mg-6Al Alloy

Finite Element Simulation of Equal Channel Angular Pressing of Ti-6Al-4V Alloy

Severe plastic deformation of commercially pure aluminum using novel equal channel angular expansion extrusion with spherical cavity

Effect of ECAE on Microstructure and Tribological Properties of Cu–10%Al–4%Fe Alloy

Effect of Friction Between Extrusion Container and Billet on Forward Extrusion Forming

Finite Element Modeling the Effect of Pressing Temperature and Temperature Rise on ECAE Process of CP-Ti

Effects of Annealing Treatment on Mechanical and Tribological Performance of Cu–10Al–4Fe after Equal Channel Angular Extrusion

Numerical simulation of friction extrusion: process characteristics and material deformation due to friction

Strain analysis of lateral extrusion process