Abstract:The present study aimed at investigating the microstructure evolution mechanism and mechanical properties of the rare earth magnesium alloy (Mg-RE alloy). The compression tests over a temperature range of 250-450 °C as well as the interrupted compression tests at a temperature of 350 °C and a strain rate of 0.1 s−1 to strains of 0.02, 0.39, 0.79 and 1.48 were conducted by using Gleeble-3800. The results show that there exists a critical transition temperature of material performance. When the temperature is lower than 350 °C, the fracture occurs at the strain of 0.31 and there was poor toughness; on the contrary, when the temperature is higher than 350 °C, there is no crack even if the strain is up to 1.49. At the same time, the material exhibited pseudo-super plastic behavior. Furtherly, the microstructure tends to be uniform and fine grains exist around some large and long grains. And, many particles emerge in the grains and at the grain boundaries. These results imply that dynamic recrystallization occurs in advance during deformation. It is found that the second-phase particles play an important role in particle stimulated nucleation effect and promote dynamic recrystallization. With further increasing strain, θ becomes negative and then tends to zero. This is because that the work hardening and strain softening compete with each other and finally reach a dynamic equilibrium. Moreover, fine grains were formed at the particles, which provided a potential path for localized shear zones. During hot deformation process, the continuous dynamic recrystallization mechanism and grain boundary strengthening were dominated. The grain growth and the particles appearance became the primary mechanism of microstructure evolution. Besides, the optimal initial reduction of 32.3% is determined. These results can help guide the development of feasible processes to enhance strength and ductility.

The Effects of RE-Mg on Thermal Fatigue Resistance of Cast High Speed Steel (HSS) Rolls

Structures and Properties of High-Carbon High Speed Steel by RE-Mg-Ti Compound Modification

Effect of RE-Al-N on Structures and Properties of M2 Cast High Speed Steel

Effects of Carbides Distribution in Matrix on Thermal Fatigue and Wear Properties of High Speed Steel Rolls

The Effect of Long-Time Austenization on the Wear Resistance and Thermal Fatigue Properties of a High-Speed Steel Roll

Study on Microstructure and Properties of High Speed Steel Roll Modified by RE-Mg-Ti

Effect of Rare Earths on Hot Cracking Resistant Property of Mg-Al Alloys

Effect of RE-Mg on High Boron Iron-Base Alloy

Effects of RE on the Microstructure and Mechanical Properties of Mg–8Zn–4Al Magnesium Alloy

Effects of RE on Microstructures of Mg-8Zn-4Al-0.3Mn Magnesium Alloys

Effects of Rare Earths on the Microstructure, Properties and Fracture Behavior of Mg–Al Alloys

Effect of Ti and rare earth on microsegregation and large-sized precipitates of H13 steel

Influence of trace rare earth elements on very high cycle fatigue behavior of hot rolled bearing steel

Cyclic Deformation Behavior of a Rare-Earth Containing Extruded Magnesium Alloy: Effect of Heat Treatment

Effect of Magnetic Field on Solidification Structure of A Centrifugal Cast High Speed Steel Roll

Effect of Complex Modification of RE-Mg on Structure and Mechanical Properties of High Boron Iron-Based Alloys

Influence of minor RE addition on microstructures, tensile properties, and creep resistance in a die-cast Mg–Al–Ca–Mn alloy

Effects of solution heat treatment on the microstructures of Mg-5Al based alloys containing Ca and RE

Influence of rare earth addition on microstructures and mechanical properties of high-pressure die casting Mg–8Zn–6Al alloy

Effects of Zn and RE Additions on the Solidification Behavior of Mg–9Al Magnesium Alloy

Microstructure Evolution Mechanism and Mechanical Properties of Mg-RE Alloy at a Critical Transition Temperature of Material Performance