Abstract:The accurate diffusivity and kinetic database of fcc quinary Cu–Co–Mn–Ni–Si system is essential for designing high-performance Cu alloys, which is still not investigated yet. In the present work, on the basis of the critically reviewed experimental diffusivities available in the literature, the atomic mobilities of fcc Mn–Ni and Cu–Mn–Ni alloys were re-assessed through CALTPP (CALculation of ThermoPhysical Properties) program, aiming to establish a self-consistent kinetic database for fcc Cu–Co–Mn–Ni–Si system. Comparing the model-calculated diffusion coefficients, composition profiles and diffusion paths with the measured ones for fcc Mn–Ni and fcc Cu–Mn–Ni alloys, it is found that the experimental data are reasonably reproduced by the re-assessed atomic mobilities, indicating their good reliability. Therefore, integrating the presently obtained atomic mobilities for the fcc Mn–Ni and fcc Cu–Mn–Ni systems with those for other sub-systems, a complete kinetic database for fcc Cu–Co–Mn–Ni–Si system was established for the first time. The reliability of the constructed kinetic database was confirmed by the reasonable agreements between the model-predicted composition profiles of sub-quaternary and quinary diffusion couples and the measured ones. Furthermore, this obtained kinetic database was applied to simulate the microstructure evolution of second-phase precipitates in Cu–Mn–Ni, Cu–Ni–Si and Cu–Ni–Co–Si alloys during the aging process, and the simulated results demonstrate good agreements with the experimental ones. The present work indicates the reliability and significance of the presently obtained kinetic database of fcc quinary Cu–Co–Mn–Ni–Si system for predicting the microstructure evolution during the heat treatment process, which can greatly contribute to the design of Cu alloys with high performance.

Thermodynamic Description of the Al–Cu–Mg–Mn–Si Quinary System and Its Application to Solidification Simulation

Phase Field Simulation for Non-Isothermal Solidification of Multicomponent Alloys Coupled with Thermodynamics Database

Thermodynamic description and simulation of solidification microstructures in the Cu–Mg–Zn system

Thermodynamic Descriptions of the Quaternary Mg–Al–Zn–Sn System and Their Experimental Validation

Thermodynamic descriptions of quaternary Mg–Al–Zn–Bi system supported by experiments and their application in descriptions of solidification behavior in Bi-additional AZ casting alloys

A thermodynamic description of the Al–Fe–Si system over the whole composition and temperature ranges via a hybrid approach of CALPHAD and key experiments

Thermodynamic Description of Multi-Component Multi-Phase Alloys and Its Application to the Solidification Process

Development and Applications of a Thermodynamic Database for Multicomponent Cu Alloys

Calculation of Phase Diagrams and Solidification Paths of Al-rich Al−Li−Cu Alloys

Thermophysical properties in the Al-Cu-Ag system: A combined CALPHAD and first-principles study

Solidification Mechanism of Ternary Quasi-Peritectic Alloy of Al-11.8cu-24.22mg

Solidification Curves of AlCu, AlMg and AlCuMg Alloys

Thermodynamic description of metastable fcc/liquid phase equilibria and solidification kinetics in Al-Cu alloys

Phase Equilibria of Sn–Sb–Cu System

Phase-field modeling of microstructure evolution of Cu-rich phase in Fe–Cu–Mn–Ni–Al quinary system coupled with thermodynamic databases

Thermodynamic Assessment of the Fe–Mn–Ni System and Diffusion Mobility of Its Face-Centered Cubic Phase

Thermodynamic Description and Simulation of Solidification Microstructure in the Co-Ti System

Diffusion kinetics for fcc quinary Cu–Co–Mn–Ni–Si system and its application to precipitation simulations

Numerical computations for temperature, fraction of solid phase and composition couplings in ternary alloy solidification with three different thermodynamic data-acquisition methods

Thermodynamic calculation of high zinc-containing Al-Zn-Mg-Cu alloy

Thermodynamic Assessments of the Al2O3-Al4C3-AlN and Al4C3-AlN-SiC Systems