Abstract:In the field of condensed matter physics and materials science, it is of great importance to investigate the microstructures, properties and solidification regularities of liquid metals. In the last few decades, the theories of solidification of binary alloys, such as dendritic growth and eutectic growths have been built. Great progress has also been made on the study of monetectic and peritectic alloys. But a solidification theory on ternary quasiperitectic alloys has not been established up to now. The study of the solidification process of quasiperitectic alloys will provide a basic work for solidification theories of ternary alloys.The master alloy of Al-11.8Cu-24.22Mg was prepared from pure Al (99.99%), pure Mg (99.99%) and Al-54.2Cu in a resistance furnace under CO2 and SF6 (volume proportion is 40 : 1) atmosphere. The melted alloy (840-850 degrees C) was pouring into different quenching graphite crucibles at the same time, and the cooling curves were recorded by a sixteen channels temperature recorder. The graphite crucible was quenched into cold-water immediately for rapid cooling at the preplanned quenching temperature. After the experiment, the microstructures of the sample were analyzed by SEM, with EDS analysis.The experiment result indicates that the primary phase is identified as S (Al2CuMg) and the quasiperitectic phases are alpha-Al and T (Al6CuMg4). The solidification microstructure is composed of remnant primary phase, quasiperitectic phases, binary eutectic and ternary eutectic. Although the quasiperitectic phases and binary eutectic are composed of the same phases (alpha-Al+T(Al6CuMg4)), their structures are different. The former structure presents strip form and the later present dendritic form. The ternary eutectic reaction is suppressed and the remnant primary S phase is reserved in the matrix with non-equilibrating crystallization.

Thermodynamic descriptions of quaternary Mg–Al–Zn–Bi system supported by experiments and their application in descriptions of solidification behavior in Bi-additional AZ casting alloys

Thermodynamic Descriptions of the Quaternary Mg–Al–Zn–Sn System and Their Experimental Validation

Thermodynamic description and simulation of solidification microstructures in the Cu–Mg–Zn system

Effect of 1wt.%Bi addition on microstructure and mechanical property of Mg–3Al alloy by twin roll casting and hot rolling

A coupled experimental and thermodynamic assessment of the Mg-Bi-Sb and Zn-Bi-Sb ternary system and extrapolate to the Mg-Bi-Zn-Sb system

Thermodynamic description of the Al–Ag–Zr system and discovery of the high-strength ternary phase Al1.84Ag0.16Zr

Thermodynamic Properties and Phase Equilibria of Sn–Bi–Zn Ternary Alloys

Thermodynamic Modeling and Experimental Investigation of the Magnesium–zinc–samarium Alloys

Thermodynamic Simulation Calculations of Phase Transformations in Low-Aluminum Zn-Al-Mg Coatings

Effect of Bi Addition on the Heat Resistance of As-Extruded AZ31 Magnesium Alloy

Phase Equilibria and Solidification of Ternary Sn–Bi–Ag Alloys

Thermodynamic study of the Ca-Cu-Zn ternary system with key experimental measurements

Phase equilibria thermodynamics and solidified microstructure in the Ag-Cr-Zr system

Thermodynamic calculation of high zinc-containing Al-Zn-Mg-Cu alloy

Ab initio and CALPHAD-type thermodynamic investigation of the Ti-Al-Zr system

Solidification Mechanism of Ternary Quasi-Peritectic Alloy of Al-11.8cu-24.22mg

Relationship of Compositions, Phase Constituents and Solidification Paths of Casting Mg-Al-Zn Alloys

Thermodynamic Modeling and Experimental Investigation of the Magnesium–neodymium–zinc Alloys

Microstructure, Non-Basal Texture and Strength-Ductility of Extruded Mg-6Bi-3Zn Alloy

Solidification Paths and Phase Components at High Temperatures of High-Zn Al-Zn-Mg-Cu Alloys with Different Mg and Cu Contents

Solidified microstructure and Phase equilibria of the Cu–Cr–X (X=Mg, Y) ternary systems