Abstract:The microstructure of Al-Cu-Li alloys is influenced by the alloying contents, which in turn affect the ultimate performance. This study examined the microstructure characteristics of Al-Cu-Li alloys with varying Li contents (1.05, 1.30, and 1.66 wt.%) in as-cast state, as well as microstructure evolution during homogenization treatments. The investigation employed a range of analytical techniques, including optical microscopy (OM), scanning electron microscopy (SEM), energy dispersive spectrometry (EDS), X-ray diffraction (XRD), differential scanning calorimeter (DSC), focused ion beam (FIB), transmission electron microscopy (TEM), and thermodynamic calculation software. The findings indicate that the eutectic phase exhibited significant variations with the Li content changing. Three distinct low-melting phases were identified in 1.05Li alloy, including Ag-containing Al 2 CuMg, Al 7 Cu 4 Li, and Al 2 Cu. As Li content was elevated to 1.30 wt.%, there was a noticeable drop in the quantities of Ag-containing Al 2 CuMg and Al 7 Cu 4 Li phases. Conversely, the Al 2 Cu phase increased, and a few Al 2 CuLi phases emerged. When the Li raised to 1.66 wt.%, an increased Al 2 CuLi phase was discovered, which existed along the dendritic edges. However, there were only little Ag-containing Al 2 CuMg phase, and no Al 7 Cu 4 Li phase detected. The initial melting temperatures for the four soluble eutectic phases were systematically arranged in the following order: Ag-containing Al 2 CuMg < Al 7 Cu 4 Li < Al 2 Cu < Al 2 CuLi. The elevated Li content resulted in a challenge of dissolution of the eutectic phases. Following 500°C/12h homogenization process, the containing-Ag Al 2 CuMg phase dissolved. Additionally, the Al 7 Cu 4 Li and Al 2 Cu phases were eliminated through subsequent 515°C/12h homogenization. In addition, the Al 2 CuLi phase was still existing.

Experimental determination of the phase equilibria of aluminum-rich Al−Li−Cu alloys

Phase Field Simulation for Non-Isothermal Solidification of Multicomponent Alloys Coupled with Thermodynamics Database

Phase Equilibria of the Al-Li Binary System

Calculation of Phase Diagrams and Solidification Paths of Al-rich Al−Li−Cu Alloys

Multi-component Phase-Field Simulation of Microstructural Evolution and Elemental Distribution in Fe–Cu–Mn–Ni–Al Alloy

Solidification Curves of AlCu, AlMg and AlCuMg Alloys

Experimental study on phase relations in the Al-Mo-Nb ternary system

Composition- and Temperature-Dependent Liquid Structures in Al–Cu Alloys: Anab Initiomolecular Dynamics and X-Ray Diffraction Study

Influence of enhanced Li content on the as-cast eutectic phase features and the evolution during homogenization of Al-Cu-Li alloys

Solidification Paths and Phase Components at High Temperatures of High-Zn Al-Zn-Mg-Cu Alloys with Different Mg and Cu Contents

Thermodynamic description of metastable fcc/liquid phase equilibria and solidification kinetics in Al-Cu alloys

The influence of Cu/Li ratio on precipitation in Al–Cu–Li–x alloys

First-principles calculations, experimental study, and thermodynamic modeling of the Al-Co-Cr system

Phase Equilibria of Sn–Sb–Cu System

New Insights into Solidification and Phase Equilibria in the Al-Al3Zr System: Theoretical and Experimental Investigations

Thermodynamic calculation of high zinc-containing Al-Zn-Mg-Cu alloy

Experimental Investigation and Thermodynamic Modeling of the Li O–Al O System

Revealing the nucleation and growth mechanisms of Fe-rich phases in Al–Cu–Fe(-Si) alloys under the influence of Al–Ti–B

Phase Equilibria and Solidification Properties of Sn-Cu-Ni Alloys

Experimental determination of the liquidus projection of the B-Cr-Ti system

Effect of Mn on eutectic phase equilibria in Al-rich Al-Ce-Ni alloys