Abstract:To bring the potential power of the capacitively coupled contactless conductivity detection ((CD)-D-4) technique to full play and extend the application fields of (CD)-D-4, our previous work has developed a (CD)-D-4 sensor which is suitable for conductivity detection of electrolyte solution in industrial fields (Sensors and Actuators A 213 (2014) 1-8). With the introduction of series resonance principle, the (CD)-D-4 sensor can overcome the influence of coupling capacitances on conductivity measurement. By a specific design of shield configuration, the (CD)-D-4 sensor can overcome the influence of stray capacitances and the environment interference in industrial fields. Although the measurement performance of the (CD)-D-4 sensor is satisfactory and it is suitable for the conductivity detection in industrial fields, the input-output characteristic of the (CD)-D-4 sensor is non-monotonic, which may limit the practical applications of the (CD)-D-4 sensor. To overcome this drawback, an improved (CD)-D-4 sensor for conductivity detection in industrial fields has been developed. The basic conductivity measurement method (the series resonance principle) and the shield configuration of the improved (CD)-D-4 sensor are the same as those of the (CD)-D-4 sensor in our previous work. However, the measurement circuit of the detection path of the improved (CD)-D-4 sensor has been optimized. The one-inductor design has been replaced by a two-inductor design. With this optimization, the input-output characteristic of the improved (CD)-D-4 sensor is theoretically monotonic. Conductivity measurement experiments were carried out on four pipes with inner diameters of 1.8 mm, 3.3 mm, 5.0 mm and 7.6 mm, respectively. The experimental results indicate that the development of the improved (CD)-D-4 sensor is successful. In comparison with the previous (CD)-D-4 sensor, the measurement accuracy of the improved (CD)-D-4 sensor is comparable. But, the improved (CD)-D-4 sensor has the advantages of the monotonic input-output characteristic and the convenience for practical conductivity detection in industrial fields. Meanwhile, it is found that the input-output characteristic of the improved (CD)-D-4 sensor is nonlinear and the sensitivity of the improved (CD)-D-4 sensor decreases with the increase of conductivity. (C) 2015 Elsevier B.V. All rights reserved.

Optimization of integrated hall sensor

Design Of On-Chip Integrated Hall Sensor

Simulation and optimization of conductor structural parameters of free-space hall-effect current sensor

Design of CMOS magnetic sensor integrated circuit

Design of a Sample-and-Hold Circuit for High Speed CMOS Image Sensor

An Improved Capacitively Coupled Contactless Conductivity Detection Sensor for Industrial Applications

A New Design of a CMOS Vertical Hall Sensor with a Low Offset

A CMOS Hall sensor modeling with readout circuitry and microcontroller processing for magnetic detection

A New Design of a Single-Device 3D Hall Sensor: Cross-Shaped 3D Hall Sensor

A 3-D GaAs-based Hall Sensor Design With Dual Active Layers Structure

A highly sensitive CMOS digital Hall sensor for low magnetic field applications

Single-Chip Integrated 3-D Hall Sensor

Analysis and Improvement of an Interface Circuit of Capacitive Sensors

Research and Optimization on Novel SPW Sensor with a High Sensitivity by Using the Double Metal Layers Structure

High Sensitivity Horizontal Hall Sensors in 0.35 um BCD Technology

A CMOS Front-End Hall Sensor Microsystem for Linear Magnetic Field Measurement With Best Tradeoff Between Sensitivity and SNR

Influences of an Aluminum Covering Layer on the Performance of Cross-Like Hall Devices

Modeling of Three-Axis Hall Effect Sensor Based on CMOS Process

Ultrasensitive Magnetic Sensors Enabled by Heterogeneous Integration of Graphene Hall Elements and Silicon Processing Circuits.

Exploring the Performance of Hall Sensor With Substrate Bias Modulation in SOI Process

Design of High-Sensitivity Cantilever and Its Monolithic Integration with CMOS Circuits