Abstract:To bring the potential power of the capacitively coupled contactless conductivity detection ((CD)-D-4) technique to full play and extend the application fields of (CD)-D-4, our previous work has developed a (CD)-D-4 sensor which is suitable for conductivity detection of electrolyte solution in industrial fields (Sensors and Actuators A 213 (2014) 1-8). With the introduction of series resonance principle, the (CD)-D-4 sensor can overcome the influence of coupling capacitances on conductivity measurement. By a specific design of shield configuration, the (CD)-D-4 sensor can overcome the influence of stray capacitances and the environment interference in industrial fields. Although the measurement performance of the (CD)-D-4 sensor is satisfactory and it is suitable for the conductivity detection in industrial fields, the input-output characteristic of the (CD)-D-4 sensor is non-monotonic, which may limit the practical applications of the (CD)-D-4 sensor. To overcome this drawback, an improved (CD)-D-4 sensor for conductivity detection in industrial fields has been developed. The basic conductivity measurement method (the series resonance principle) and the shield configuration of the improved (CD)-D-4 sensor are the same as those of the (CD)-D-4 sensor in our previous work. However, the measurement circuit of the detection path of the improved (CD)-D-4 sensor has been optimized. The one-inductor design has been replaced by a two-inductor design. With this optimization, the input-output characteristic of the improved (CD)-D-4 sensor is theoretically monotonic. Conductivity measurement experiments were carried out on four pipes with inner diameters of 1.8 mm, 3.3 mm, 5.0 mm and 7.6 mm, respectively. The experimental results indicate that the development of the improved (CD)-D-4 sensor is successful. In comparison with the previous (CD)-D-4 sensor, the measurement accuracy of the improved (CD)-D-4 sensor is comparable. But, the improved (CD)-D-4 sensor has the advantages of the monotonic input-output characteristic and the convenience for practical conductivity detection in industrial fields. Meanwhile, it is found that the input-output characteristic of the improved (CD)-D-4 sensor is nonlinear and the sensitivity of the improved (CD)-D-4 sensor decreases with the increase of conductivity. (C) 2015 Elsevier B.V. All rights reserved.

High Sensitivity Horizontal Hall Sensors in 0.35 um BCD Technology

A New Design of a Single-Device 3D Hall Sensor: Cross-Shaped 3D Hall Sensor

A New Design of a CMOS Vertical Hall Sensor with a Low Offset

A highly sensitive CMOS digital Hall sensor for low magnetic field applications

Design of CMOS magnetic sensor integrated circuit

An Improved Capacitively Coupled Contactless Conductivity Detection Sensor for Industrial Applications

Design of Capacitively Coupled Contactless Conductivity Detection Sensor

Optimization of integrated hall sensor

Design and optimization of a new type of contactless radial C4D sensor

Design and Implementation of an Industrial C4D Sensor for Conductivity Detection

Design Of On-Chip Integrated Hall Sensor

Single-Chip Integrated 3-D Hall Sensor

A 3-D GaAs-based Hall Sensor Design With Dual Active Layers Structure

Simulation and optimization of conductor structural parameters of free-space hall-effect current sensor

A Mask-Misalignment Offset Reduction Method for Design of Cross-Like CMOS Hall Devices

Highly Sensitive Hall Sensor For Brushless Dc Motor

Nanoscale Vacuum Channel Hall Sensors

Design and Implementation of High-Precision Current Measurement Instrument Based on Hall Sensor

Exploring the Performance of Hall Sensor With Substrate Bias Modulation in SOI Process

A CMOS Front-End Hall Sensor Microsystem for Linear Magnetic Field Measurement With Best Tradeoff Between Sensitivity and SNR

Feasibility study of CMOS sensors in 55 nm process for tracking