Abstract:To solve the problem that we always need external crystal to provide clock for the chip in the USB full speed equipment,an implemented method of low power consumption phased locked loop(PLL) applying to the USB full speed equipment is proposed.According to the data transmission rate in the USB full speed equipment,based on the standard phase locked loop structure,a clock information extraction unit and a low power control module are added,an improved phase frequency detector(PFD) and differential voltage controlled oscillator(VCO) is implemented to the proposed phase locked loop.And the phase locked loop layout is completed with 0.35 μm technology.Furthermore,the performance of proposed phase locked loop is verified,and the results meet the requirement of the USB protocol.

Design of Host/Device Control FSM for USB OTG Dual-Role Controller

Design of USB Floppy Driver Based on WinCE

Design of Data Communication Interface of Data Acquirement System Based on USB

Design of Phase Locked Loop Applying to USB Full Speed Equipment

Design of the operating mode control cicurt of the USB2 . 0 device controller

Implementation of a USB2.0 Device Based on SOPC

Research on Software-hardware Co-design Methodology for USB2.0 Host Controller in SoC System

The Design and Development of USB 2.0 Interface IP Core

Design and Implementation of USB1.1 Controller

Real-time Bidirectional Data Transmission Based on USB Interface

Design and Realization of Low Cost USB Protocol Converter

Design of device driver based on stream interface driver model under WinCE

USB Peripheral Device and its FPGA Implementation

Design of USB HID Device Based on Single Chip C8051f340

USB2 . 0 transceiver logic circuit design based on UTMI specification

Communication Between Cellphone and STM32 Through USB OTG

Design of SDIO host controller of CK-Core based processor

Low Pin Count Interface for USB2.0 Host Controller in SOC System

A Method of Implementation FPGA SelectMap Configuration on USB Interface

Design of an FPGA-based USB 3.0 device controller

Design of Upper Computer System of High-End Loom Machine Controller Based on AT9261 and CAN Bus