Abstract:To improve the casting quality as well as the casting efficiency during the casting process, the effect of the interaction of process parameters and system structural parameters on the shrinkage volume and efficiency of the casting was investigated in this paper by using the response surface method for the simulation prediction of A356 alloy sand casting. The relationship between variables and response (shrinkage volume, solidification time) was established by Box-Behnken Design with pouring temperature (650–710 °C), mold preheating temperature (200–300 °C), width/thickness ratio of cross-section of sprue (1.2–1.5), width/thickness ratio of inner sprue section (2–4) and length/diameter ratio of straight sprue (1.5–2.5) as variables by the response surface method. The results are then optimized, and the optimal solution is selected by the NSGA-II algorithm and TOPSIS method. The results show that the changes in the cavities of the optimized and improved pouring system enhance the flow of the metal fluid and make the filling more complete. The gentle cooling of temperature is conducive to heat dissipation and layer-by-layer sequential solidification, which can effectively eliminate the casting's internal shrinkage loosening and shrinkage holes defects, thus forming a dense casting with good performance. After solving the optimized parameters and improving the pouring system, the solidification time (integrated solidification time) was reduced from 129.24 to 88.10s, and the shrinkage volume was reduced from 9.68 to 4.06 cm 3 .

Development of Pressure Control System in Counter Gravity Casting for Large Thin-Walled A357 Aluminum Alloy Components

Fuzzy neuron hybrid control for continuous steel casting

Fuzzy Neuron Control for Continuous Steel Casting

Optimization of Valve Body Process Based on HZCAE

Utrahigh Pressure Control Method Based on Fuzzy PID

A Neuron Model-Free Controller with Fuzzy Tuning Gain for Continuous Steel Casting Processes

Process Optimization of Low-pressure Die Casting of Aluminum Alloy Wheel based on Taguchi Method

Modelling And High-Precision Constant Pressure Control Of The Pneumatic Suspension System

Expert-PID Synchronization Control of Thrust Hydraulic System

Prediction method of shrinkage cavity and shrinkage porosity in solidification process under low-pressure casting

Accurate Simulation of Complex Temperature Field in Counter-Pressure Casting Process Using A356 Aluminum Alloy

High Precision Pressure Control in Large Closed Water Volume

Study on Casting Defect Control of Austenitic 304 Complex Structural Parts

The Design of Low Cost Valve-and-pump Compounded Pressure Control System for the Hydro Viscous Clutch

A fuzzy PID controller with nonlinear compensation term for mold level of continuous casting process

Quality Control Study on High Pressure Casting Based on Magma and Ultra-red Simulation

Finite element analysis for die casting parameters in high-pressure die casting process

Computer-Aided Engineering (CAE) Simulation for the Robust Gating System Design: Improved Process for Investment Casting Defects of 316L Stainless Steel Valve Housing

Computer-Aided Designs Of Die And Thermal Control For Fabrication Of A356 Wheels

Optimization of Casting System Structure Based on Genetic Algorithm for A356 Casting Quality Prediction

Dynamic Secondary Cooling of Continiuous Slab Casting by Incremental PID Control