Abstract:Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications, Ahead of Print. After pneumatic shot peening, compressive residual stress is induced on the surface of the target, which will improve the fatigue life. During the process, surface roughness is also induced, which may reduce the fatigue life. To achieve the optimum compressive residual stress with the smallest surface roughness, the formation mechanism of the residual stress field and the surface topography are revealed. Then, pneumatic shot peening is simulated by using a discrete element method–finite element method coupled model. Based on the effects of four variables (the incident angle θ, the initial shot velocity v0, the shot radius R) and the mass flow rate rm on five parameters (the equivalent plastic strain, the equivalent stress, the surface compressive residual stress, the maximum compressive residual stress), the surface roughness is investigated. The results show that it induces a residual elastic–plastic strain after the impact of a single shot, which can form a crater and a hemispherical residual stress field. After the impact of many random shots, scattered craters connect with each other, therewith a rough and continuous surface topography is formed. Scattered residual stress fields couple with each other, and a constant residual stress layer with the compressive residual stress in the surface and the tensile residual stress in the subsurface are formed. All five parameters are determined by the residual elastic–plastic strain, which increases as the augment of the normal impact velocity, the shot mass, and the coverage rate. Along with the increase of θ and rm, these five parameters firstly increase and then decrease; with the increase of v0 and R, these five parameters increase. Therefore, reasonable values of θ, v0, R, and rm should be chosen to obtain the optimum compressive residual stress with as small surface roughness as possible.

Energy Conversion and Residual Stress Distribution in Shot Peening Process

Studies on residual stress and surface topography after pneumatic shot peening using discrete element method–finite element method coupled model

An analytical model for predicting residual stress in shot peening with strain energy method

Analysis of Residual Stresses and Three Dimensional Stress Intensity Factors for Shot Peened Single-edge-notch-tension Specimens

Investigation on Experiments and Numerical Modelling of the Residual Stress Distribution in Deformed Surface Layer of Ti–6Al–4V after Shot Peening

Calculation of Relaxation of Residual Stress and Change of Yield Strength in Shot Peened Layer

Finite Element Analysis for Shot-Peening Models of Single Shot Impact and Multiple Impingement

Investigation of the effects of shot overlap and rigid body assumptions on surface layer characteristics in shot peening simulation

Uniformity of residual stress distribution on the surface of S30432 austenitic stainless steel by different shot peening processes

Numerical modeling of ultrasonic shot peening with an accurate impact velocity

Numerical simulation on influencing factors of micropartical shot peening

Experimental Study on the Effect of Shot Peening and Re-Shot Peening on the Residual Stress Distribution and Fatigue Life of 20CrMnTi

Shot Stream Finite Element Model for Shot Peening Numerical Simulation and Its Experiment Study

The influence of shot peening process on the residual stress and microstructure in deformed surface layer of S30432 austenitic stainless steel

A simulation modeling methodology considering random multiple shots for shot peening process

A theoretical model for predicting the surface topography of inhomogeneous materials after shot peening

Analysis of residual stress of gear tooth root after shot peening process

Multiphysics Modelling of Warm Shot Peening of AISI 4140 Steel

Investigation on the non-homogeneity of residual stress field induced by laser shock peening

The residual stress varying of shot peened TC4-DT titanium alloy

Molecular modeling of Ti-6Al-4V alloy shot peening: the effects of diameter and velocity of shot particles and force field on mechanical properties and residual stress