Abstract:In this paper, a series of experiments including room-temperature low-cycle fatigue tests, instrumented indentation measurements, optical microscopy examinations, etc. were carried out to study the local mechanical properties and microstructures in particular zones of 304L SS welded joints in both the as-welded and cyclic straining conditions. An analytical algorithm proposed by Dao et al. [12] was utilized to estimate the basic mechanical properties (E, σy and n) from the indentation load-depth data. It is shown that in the as-welded condition, the weld metal has a higher strength and strain hardening capacity but a lower stiffness than does the base metal, while the material within HAZ exhibits a significant gradient of the mechanical properties. A strain amplitude-dependent variation in the local mechanical properties in particular joint regions was also obtained. Optical microscopy examinations showed that the microstructure in particular zones of 304L SS welded joints was not only decided by the metallurgical condition resulting from the welding process, but also determined by the strain amplitude applied during cyclic straining. In this study, an empirical criterion for judging the fracture locations of a weldment based on the yield stress mismatch ratio was also introduced to assess the integrity of the present 304L SS welded joints subjected to low-cycle fatigue loadings. The research work performed in this paper would further expand the applications of instrumented indentation technique in fatigue strength analysis of welded components.

Stress Intensity Factors for Spot Welds Joining Sheets of Unequal Thickness

Assessing the Residual Stresses in Dissimilar Welded Joint: Depth-Sensing Indentation Testing and Numerical Simulation

Stress Intensity Factors for Cracked Cold-drawnSteel Wires under Tensile Loading

Stress intensity factors for spot welds between plates of dissimilar materials

Depth-sensing Indentation Measurement and Finite Element Analysis of Residual Stress Field Near Fatigue Crack Tip

Use of instrumented indentation testing to study local mechanical properties of 304L SS welded joints subjected to low-cycle fatigue loadings

Fracture mechanics solutions to spot welds

A Strain Gauge Method for Spot Weld Testing

A Simplified Spot Weld Model for Finite Element Analysis

Recent developments in analysis and testing of spot welds

Experimental and Numerical Investigation of Mechanical Properties and Stress Intensity Factor of Dissimilar Spot Weld Joints

3D BE Analysis on Stress Intensity Factor of a Fatigue Crack in a Welded T-joint

Study on Stress Intensity Factor of Girth Weld with Crack Defects

Residual Notch Stress Intensity Factor assessment via 3D welding numerical simulation: influence of power input

A Fatigue Life Prediction Approach for Resistance Spot Welded Joints with Consideration of the Stress Ratio Effect

Experimental Evaluation of Stress Concentration Factor of Welded Steel Bridge T-Joints

Effect of Loading Methods on the Fatigue Properties of Dissimilar Al/Steel Keyhole-Free FSSW Joints

A spot weld element formulation and implementation for mesh‐insensitive fatigue evaluation of lightweight structures

Development of Stress Intensity Factors for Subsurface Flaws in Plates Subjected to Polynomial Stress Distributions

Fatigue Analysis of Typical Welded Joints of Steel Bridges Using Effective Notch Stress Approach

Calculation of stress intensity factor based on the extended finite element method